Symphonic SV206G Owner's Manual - Page 16

TROUBLESH 0 TING GUI E If you have followed the instructions contained in this manual and have difficulty in operating the VCP, locate the SYMPTOM in the left column below. Check the corresponding POSSIBLE CAUSE and CORRECTIVE ACTION columns to remedy the problem. SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION No power. • Power cable is not connected. • Connect power cable to AC outlet. • Power is turned off. • Press the POWER button to turn on. No picture or poor picture on play- • The TV fine tuning is not set • Fine tune your TV. back. correctly. Noise in picture on playback. • Video heads are dirty. • Head cleaning is necessary, consult the service center. Playback picture is partially noisy. • The Tracking control is not set • Adjust Tracking control for better correctly. picture. The TV programmes cannot be • Connections are not correctly • Re-check the ANT-IN and ANT- seen. made. OUT connections. • The VCP power is on. • Turn off the VCP. No operation by the remote con- • Weak battery. trol. • Check the batteries of the remote control. Power indicator flashes. • The dew sensor is on. • Refer to page 4 "DEW WARNING". MAINTENANCE SERVICING AUTO HEAD CLEANING Should the VCP become inoperative, do not try to correct the problem by yourself. There are no user-serviceable parts inside. Turn off, unplug the power cord, and take the unit to a Funai Authorized Service Center for servicing. CABINET CLEANING • Wipe the front panel and other exterior surfaces of the VCP with a soft cloth immersed in lukewarm water and wrung dry. • Never use a solvent or alcohol. Do not spray insecticide liquid near the VCP. Such chemicals may cause damage and discoloration to the exposed surfaces. • Automatically cleans heads as you insert or remove a cassette, so you can see the clear picture. • Playback picture may become blurred or interrupted while the TV program reception is clear. Dirt accumulated on the video heads after long periods of use, or the usage of rental or worn tapes can cause this problem. If a streaky or snowy picture appears during playback, the heads of the VCP may need to be cleaned. 1. Please visit your local Audio/Video store and purchase a good quality VHS Video Head Cleaner. 2. If a Video Head Cleaner does not solve the problem, consult the nearest Funai Authorized Service Center. Professional video head cleaning requires highly technical attention. NOTES: • Remember to read the instructions included with the head cleaner before use. • Clean heads only when problems occur. - 16 - EN 7D11