Symphonic TRWF130 Owner's Manual - Page 25
TV/VCR's
View all Symphonic TRWF130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
OTC. (One Touch Itec()rdino) This function enables you to set a recording length simply by pressing the REC/OTR button on the TV/VCR. Make sure ... • TVNCR power must he turned on. Push(es) 1 push 2 pushes 3 pushes 4, 17 pushes Display Recording length (normal recording) 0:30 30 *minutes 1:00 60 minutes 4, 4- 8:00 480 minutes • Insert a cassette tape with its erase prevention tab in place. (If necessary. rewind or fast forward the tape to the point at which you want to begin recording.) NOTES: • This function CANNOT be done from the remote COPYING A VIDEO CASSETTE (Re uires a VCR or camcorder) You can make copies of video tapes made by friends or relatives for your enjoyment. control. • Recording starts immediately when the REC/OTR button is pressed. WARNING: Unauthorized recordings of copyrighted video tapes may be an infringement of copyright laws. • When the REC/OTR button is pressed 18 times, the TV/VCR returns to the Normal Recording mode. • To stop the OTR operation, press the STOP button on the TVNCR or on the remote control. Connect your TV/VCR and a Source (Haying) VCR using the following diagram. [Fig.8] • To show the remaining time, press the DISPLAY button on the remote control so that "OTR" appears on the TV screen. (It will show up momentarily then disappear.) [The TVNCR] 0 • Recording stops when 0:00 is reached. • • Please note that in the SLP mode maximum record- ing time, assuming the tape is started at the begin- ning, is 8 hours using T-160 (or 6 hours using T-120). • If the tape runs out before the end time, the TVNCR will switch to the Stop mode immediate- [Ex: Source (playing) VCR or camcorder] ly, ejects the tape and turns itself off. AudioNideo 1 Select the channel to be recorded Press the number buttons on the remote control or the adapter cable (not supplied) CHANNEL A or 'V button. Remember: If the TV/VCR is connected to a cable box or satellite box, the TV/VCR must be on CH3 or CH4, then the channel to be recorded is selected on the cable box or satellite box. 1)Insert a pre-recorded video cassette into the Source (Playing) VCR or camcorder. 2)Insert a blank video cassette, or one you want to record over, into the TV/VCR's cassette compart- ment. 2 Select the tape speed Press the SPEED button to select the desired tape speed (SP/ SLP). 3)Press the SPEED button on remote control for the TV/VCR to select the desired recording speed (SP/SLP). 4)Press the CHANNEL A or V button on the TVNCR until "AUX" appers.on the screen. 3 Begin OTR OTI:q2 X) 5)Press the RECORD button on the TV/VCR. Press the REC/OTR button on the 6)Begin playback of the tape in the source (Playing) TVNCR as many times as needed. The recording length will be determined by the number of times you press the REC/OTR button. Each additional push will increase the recording time by 30 minutes. It is set up VCR or camcorder. NOTE: For best results during dubbing, use the TV/VCR's &tint panel controls whenever possible. The remote control might affect the source (Playing) to 8 hours. VCR's playback operation. 25 - EN 9103