TASCAM BD-MP1 Owners Manual - Page 26

Turning the unit on and off NOTE When this unit is connected by a power cord and electricity is supplied from an outlet, it will automatically start up. (This will also occur when power is restored after a power outage or other interruption to the power supply.) If the STANDBY/ON indicator on the front of the unit lights red, press the button or the remote control STANDBY/ON button. HELLO Startup screen BD BDMV USB Operation screen After the unit starts and the startup screen is shown, the operation screen will appear on the display. Turning the unit off Press the button or the remote control STANDBY/ON button to turn the unit off. ATTENTION Do not turn the power off or disconnect the power cord when the unit is operating (including playing back or writing data to a USB flash drive). Doing so could damage the unit. Loading and removing discs Inserting and removing SD cards Inserting SD cards Insert an SD card into the SD card slot on the front of the unit to enable playback. TIP SD cards can be inserted whether or not the unit is on or off. iiInserted SD cards with the correct orientation. iiThe label should be up and the connector should be inserted toward the back. Removing SD cards Turn the unit off or stop operation before removing an SD card. ATTENTION Do not remove an SD card when the unit is operating (playing back an SD card). Doing so could cause proper dubbing to fail, data to be lost, and sudden loud noises from monitoring equipment, which might damage the equipment, harm hearing or cause other trouble. 1. Press the SD card in gently to make it to come forward. 2. Pull the SD card out by hand. SD card write protection switches SD cards have write-protection switches that prevent writing new data to them. Loading discs Press the OPEN/CLOSE (-) button on the main unit or remote control. Open the disc tray and place the disc on it with the label side up. Press the OPEN/CLOSE (-) button again to close the disc tray. After loading a disc, the unit will read its information and show the media type on the display. NOTE iiWhen the disc tray is open, "OPEN" will appear on the display. When the disc tray is open, "CLOSE" will appear on the display. iiIf a disc other than a playable CD is inserted or a disc is inserted upside down, the unit will automatically eject it. Ejecting discs Press the OPEN/CLOSE (-) button on the main unit or remote control. After the disc tray opens, pick the disc up by its center and remove it. NOTE The OPEN/CLOSE button functions when the unit is turned on. Connecting and disconnecting USB flash drives Connecting USB flash drives Connect a USB flash drive to the USB port on the front or back of the unit to enable playback. TIP You can connect a USB flash drive when the unit is on or off. Disconnecting USB flash drives Turn the unit off or stop operation before disconnecting a USB flash drive. ATTENTION Never disconnect a USB flash drive when the unit is operating (including playing back or writing data to the USB flash drive). Doing so could cause the loss of data or damage the unit. 26 TASCAM BD-MP1