TASCAM CD-D1X4 x4 Owners Manual - Page 12
Additional copy modes
View all TASCAM CD-D1X4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
4 - Basic operations audio) until a final table of contents (TOC) has been written at the start of the disc. The process of writing this table of contents is known as "finalizing" and is performed automatically by the Additional copy modes This is an option accessed from the SETUP menu, allowing you to set the different copy modes. There are five such modes: • Copying (COPY), which copies the contents of a disc from the master drive to any slave drives with discs inserted. • Verifying already copied data (VERIFY). NOTE The verify option is not available for the following types of disc: CD-DA (audio CDs), CD-ROM XA Form 2 discs and CD-EXTRA discs. • Copying with verification (COPY+V). Copying followed by verification (as above). The same restrictions apply to the verification process as apply to verification alone. During this process, the display shows COPY+V/C during the copy phase of the operation, followed by COPY+V/V during the verification phase. • Read check (RD CHECK). This provides a check as to whether the target discs can be read correctly after they have been copied. NOTE Note that when an audio disc is checked after copying or recording, no error will be shown unless the disc is very badly damaged (large audible errors). Any checking on a disc containing errors may take a significantly longer time than checking a good disc. • Copy with read check (COPY+R). Copying, followed by the read check as described above. During this process, the display shows COPY+R/C during the copy phase, followed by COPY+R/R during the read check. 1 Press the MODE key until the display shows: SETUP? (MODE CHANGE) CD-D1x4. Once this has been done, no further data can be written to the disc. In the case of a CD-RW disc which has been finalized, the whole of the disc may be erased, and the disc re-used. 2 Press ENTER, The screen should show:. >MODE SELECT? (COPY) The bottom line of the screen may be different, depending on the currently-set mode. 3 Press ENTER again. 4 Press the MODE key until the mode to be used appears on the screen (from the list above). Press ENTER to confirm the setting. Pressing the ESCAPE key takes you back a level without changing anything. 5 If you select the verification or read check operations, you should press ESCAPE until the screen shows: VERIFY START? or RD CHECK START? 6 Press ENTER to start the operation. The drive trays open automatically. Put the discs to be verified or checked into the drives, and when this is done, the drives have been closed, and the unit has recognized all the discs (the drive indicators have gone out), press ENTER. The verification or read check process then starts. 12 TASCAM CD-D1x4