TASCAM CD-D1X4 x4 Owners Manual - Page 20
To clear an error, Error messages
View all TASCAM CD-D1X4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
8 - Error messages and troubleshooting To clear an error When an error is shown, the unit beeps continuously to attract your attention. To clear the error and stop the beeping, open the drive mentioned in the error message. Error messages ERROR SOURCE alone, or ERROR DRIVE x alternating with ERROR SOURCE may be shown in the case of a dirty, damaged or scratched disc being loaded into the MASTER drive. Check that the disc is properly loaded, and clean the disc if necessary In other cases, ERROR DRIVE x or ERROR SOURCE is shown on the top line, with one of the errors below shown on the bottom line if one of the drives encounters an error during a process. x refers to the number of the slave drive. CODE xxxx is shown if an internal error occurs. Make a note of the number represented by xxxx and contact your TASCAM supplier (the number is used by the service engineers, and may be shown together with another message). SOURCE ANALYZE is shown if an error occurs while analyzing the source disc. Check the master drive loading, and clean the disc if necessary. VERIFIY ERROR is shown if an error occurs while verifying a recorded disc. Try again with another disc. DISC ERROR is shown when an unrecognizable disc (for example one that was created when power was turned off during a copy operation) is inserted. DISC TYPE is shown if the source disc to be copied is of the wrong type to be copied (or it may be copy-protected). Only copy discs as specified in this manual. JOB ABORTED indicates a process halted by you before it has come to an end. No action necessary. DATA SIZE is shown in verification operations if there is a difference between the source and target discs. TIME OUT indicates a time-out error with one of the drives. Try again. CAPACITY ERROR indicates that the target disc is the wrong size for the data you are trying to copy. Make sure the target disc is the right size for the data you are copying. The standard maximum length of an audio CD is set at 74 minutes. However, some commercial CDs are recorded with a running time a little longer than this. If any of these errors occur, correct the problem, if possible (replace the offending disc correctly in the disc tray, try again with a different disc, etc.) before attempting the copy operation again. 20 TASCAM CD-D1x4