TASCAM DM-24 Downloads Update Instructions IF-FW:DM only - Page 6

Initialization Process - factory reset

Get TASCAM DM-24 PDF manuals and user guides View all TASCAM DM-24 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

18. Press the soft key below where you see PREFERENCES on the LCD. 19. Use the cursor keys to point to VERSION INFO and press ENTER. You will see a list of different files. All of them except for Download should be labeled with the upgraded version you just loaded. If not, you will need go through the procedure again. IF­FW/DM: This component is not updated as part of V3.00 and will still show a previous version number. This is normal. 20. Once finished, you will need to initialize your DM­24 as follows. INITIALIZATION PROCESS 1. With the power OFF hold down the 2nd F button (far left of the board), the HIGH button (just above in the EQ section) and the minus button (just to the right in the LIBRARY section) while you turn the power ON. 2. The DM­24 will boot to DIAGNOSTIC MODE. As soon as you see DIAGNOSTIC MODE on the display you may release the 2nd F, HIGH and - buttons. 3. Use the "Down cursor key" to move the indicator to SRAM INIT (NOT SRAM INIT for factory TEST) and press ENTER. 4. Press ENTER again to confirm when prompted. A check mark will appear in the box next to SRAM INIT on the display. 5. Use the "Down cursor key" to move the indicator to FLASH INFORMATION CLEAR and press ENTER. 6. Press ENTER again to confirm when prompted. A check mark will appear in the box next to FLASH INFORMATION CLEAR on the display. 7. Use the "Down cursor key" to move the indicator to EXIT and press ENTER. This will reset the DM­24 back to the original factory settings and the DM­24 will reboot.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
18. Press the soft key below where you see PREFERENCES on the LCD.
19. Use the cursor keys to point to VERSION INFO and press ENTER.
You will see a list of different
files. All of them except for Download should be labeled with the upgraded version you just loaded. If
not, you will need go through the procedure again.
IF±FW/DM:
This component is not updated as
part of V3.00 and will still show a previous version number. This is normal.
20.
Once finished, you will need to initialize your DM±24 as follows.
INITIALIZATION PROCESS
1.
With the power OFF hold down the 2nd F button (far left of the board), the HIGH button (just
above in the EQ section) and the minus button (just to the right in the LIBRARY section) while
you turn the power ON.
2.
The DM±24 will boot to DIAGNOSTIC MODE. As soon as you see DIAGNOSTIC MODE on the
display you may release the 2nd F, HIGH and – buttons.
3.
Use the “Down cursor key” to move the indicator to SRAM INIT (NOT
SRAM INIT for factory
TEST) and press ENTER.
4.
Press ENTER again to confirm when prompted. A check mark will appear in the box next to
SRAM INIT on the display.
5.
Use the “Down cursor key” to move the indicator to FLASH INFORMATION CLEAR and press
ENTER.
6.
Press ENTER again to confirm when prompted. A check mark will appear in the box next to
FLASH INFORMATION CLEAR on the display.
7.
Use the “Down cursor key” to move the indicator to EXIT and press ENTER. This will reset the
DM±24 back to the original factory settings and the DM±24 will reboot.