TASCAM HS-8 Firmware V1.40 Instruction Manual - Page 6

HS-8 VNC (virtual network computing) By using a VNC viewer application, you can view and operate the contents of this unit's LCD screen on a computer. In the VNC viewer application, you can use a mouse to conduct the following operations. iiMouse left click: Same as touching the unit's LCD. iiMouse wheel click: Same as pressing the unit's ENTER key. iiMouse wheel operation: Same as using the unit's DATA dial. iiMouse wheel push and turn: Same as using the unit's DATA dial while pushing it to make large setting changes (COARSE mode operation). In addition, when the VNC viewer application is active, you can conduct the following operations by using the computer keyboard. iiF1 to F12 keys: These work the same as an external keyboard connected to the unit. For details see the "List of keyboard operations" in "Operation using a computer keyboard" in "12 - Other functions" of this unit's manual. iiHome key: This works the same as this unit's HOME key and opens the Home Screen. Press the End key while pressing and holding the Home key to open the LOCK SETUP screen. iiEnd key: This works the same as this unit's MENU key and opens the MENU screen. Press the End key while pressing and holding the Home key to open the LOCK SETUP screen. iiPage Down: This works the same as this unit's PROJECT key and opens the PROJECT screen. ii2 key: This works the same as turning this unit's DATA dial right. iix key: This works the same as turning this unit's DATA dial left. iiCharacter input keys: Use to input characters when a keyboard screen appears on the unit. Necessary setting for VNC connections The following settings are necessary for connecting to this unit using a VNC viewer application. IP address: This unit's IP address is shown in the IP Address field of the REMOTE SETUP screen ETHERNET page. Password: HS-8 (default, case sensitive) This setting can be changed by using the Password Change button on the REMOTE SETUP screen ETHERNET page. NOTE ii 2 or more simultaneous VNC connections are not possible. ii When EXTERNAL Control has been set to LOCK on the Lock Setup screen, display is possible but operation is not when using a VNC viewer application. ii Changing any settings on the REMOTE SETUP screen of the ETHERNET page will also end any active VNC connection. ii For information about VNC viewer application that have been confirmed to work properly with this unit, please contact TASCAM customer support. ii When files are being transferred by FTP or when the system sampling frequency is 88.2 or 96 kHz, VNC viewer application display and operation will not be smooth. REMOTE/KEYBOARD and EXTERNAL Control Lock/Unlock settings added REMOTE/KEYBOARD and EXTERNAL Control Lock/Unlock settings have been added on the LOCK SETUP screen. 00 When REMOTE/KEYBOARD is set to LOCK, if a remote control or keyboard connected to a remote connector is used, the following pop-up message appears when remote/keyboard control is locked. 00 When EXTERNAL CONTROL is set to LOCK, if an operation is conducted using RS-232C, RS-422, PARALLEL or ETHERNET, the following pop-up message appears when external input is locked. Take Rename function A function has been added that allows you to change the names of takes. Follow the procedures below to do so. 1. On a take selection screen, select that take that you want to rename. 2. Touch the MENU button on the take selection screen to open a pull-up menu (An EDIT NAME button, which is shown framed in red below, has been added to this pull-up menu). 3. Touch the EDIT NAME button in the pull-up menu to open the TAKE NAME screen. (On this TAKE NAME screen, you can change the input take name.) 6 TASCAM HS-8 NOTE When multiple takes are selected, you cannot use the EDIT NAME button in the pull-up menu. 4. Edit the take name. 5. Touch the Enter button on the TAKE NAME screen or press the DATA dial to confirm the changed take name and return to the take selection screen.