TASCAM HS-P82 Owners Manual - Page 11

Rear panel 2 − Names and functions of parts i Battery compartment Open the cover to install batteries. See page 17 for information about the types of batteries that can be used. o V-Mount bracket attachment holes You can attach the included V-Mount bracket here. (See "Attaching a V-Mount type battery" on page 18.) p Kensington lock mounting hole Right side panel a LINE OUT connectors Connect a monitor speaker system or other equipment to these balanced XLR analog connectors (1: GND, 2: HOT, 3: COLD) that output the internally-mixed stereo signal. s MIC/LINE selection switches Set these switches according to the type of input signal. MIC 0: Use when inputting a microphone. MIC -25: Use when inputting a microphone. This applies a 25 dB pad to the mic input. LINE: Use for line level input. d MIC/LINE IN connectors These are XLR balanced analog input connectors (1: GND, 2: HOT, 3: COLD). Their standard and maximum input levels depend on the settings of the MIC/LINE selection switches. CAUTION •• Confirm that phantom power is OFF before connecting a line level device to a MIC/LINE IN connector. If you connect a line level device while phantom power is ON, that device or this unit could be damaged. •• Confirm that phantom power is OFF before connecting or disconnecting a condenser microphone to a MIC/LINE IN connector. If you connect a microphone while phantom power is ON, that mic or this unit could be damaged. •• Do not connect an unbalanced dynamic microphone to an XLR connector that is supplying phantom power. Doing so could damage the microphone or this unit. 11 TASCAM HS-P82