TASCAM HS-P82 Owners Manual - Page 21
Battery display, STATUS, AC/DC EXT/BATT, NP type batteries, Batteries using the supplied battery case
View all TASCAM HS-P82 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
3 − Preparation Battery display At the top right of every screen is a button that opens the power screen. Touch this button to open the BATTERY management screen. STATUS This shows the currently active power source. AC/DC EXT/BATT The indicator for the currently active power source appears green. The current voltage for each power source is shown beneath its HEALTH label. The type of battery currently installed in the unit is shown beneath the BATT label. NONE: No internal battery is installed NP: Shown when an NP type battery is installed PACK: Shown when a battery case (BC-10AA) is installed The following settings can be made for the DC EXT and BATT items. •• MINIMUM: Set the minimum battery voltage between 9.0 V and 13.0 V in 0.5 V steps (default value: 10.5V) •• NOMINAL: Set the usual voltage to 12.0 V (default value), 13.2 V, 14.4 V, 14.8 V or 15.0 V The recommended values depending on the type of battery are as follows. NP type batteries Type of batteries Minimum voltage Nominal voltage NiMH 12.0 V 11.0 V 12.0 V NiMH 13.2V 12.0 V 13.2 V Li-Ion 14.4V 13.0 V 14.4 V Li-Ion 14.8 V 13.0 V 14.8 V Deep cycle lead 10.5 V 12 V 12.0 V Batteries (using the supplied battery case BC-10AA) Type of batteries Minimum voltage Nominal voltage NiMH rechargeable batteries (AA) 10.5 V 12.0 V Alkaline batteries 9.0 - 9.5 V (AA) 15.0 V The minimum and nominal voltages in the above tables are typical values of commercially available batteries. Please set them according to the battery manual. CAUTION If the minimum voltage is too low, there is a danger of damaging rechargeable batteries through excessive discharge. NOTE A great amount of power is required to provide phantom power to a condenser microphone. If you use a condenser microphone while running the unit on AA batteries (NiMH rechargeable or alkaline), the operation time will be greatly shortened because of their low capacities. If you need to operate the unit for a long time, use the AC adaptor or a battery with great capacity. Touch the area of the value that you want to change. When the background color changes, use the DATA dial to set the value. ICON TYPE (Battery status display): You can set the battery status display icon type by touching the BARS ( / ) or VOLTS ( / ) button. The default value is BARS. 21 TASCAM HS-P82