TEAC CDW54E User Manual - Page 12

X: Strap shorted - cd w54e

Get TEAC CDW54E PDF manuals and user guides View all TEAC CDW54E manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

ENGLISH With S1 open (jumper not set) the TEAC CD-W54E ist set to single or slave mode by setting the jumpers S2 and S3. The set mode is irrespective of the CSEL signal. Master/slave mode is determined by CSEL if S1 is shorted (jumper set). In this case S2 and S3 are irrespective for setting the mode. Note: When setting modes using these straps, be sure to switch off the CD-RW drive before doing so. S1 S2 S3 Remarks CSEL. Master or Slave drive is set by using X - - CSEL terminal. (DASP signal is used to recognize slave drive. If slave is absent, the shadow register is used.) - X - Slave Master (DASP signal is used to recognize - - X slave drive. If slave is absent, the shadow register is used.). Remark: X: Strap shorted -: Strap open 4. Controls and Functions 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
35
ENGLISH
4. Controls and Functions
With S1 open (jumper not set) the TEAC CD-W54E ist set to sin-
gle or slave mode by setting the jumpers S2 and S3. The set mode
is irrespective of the CSEL signal. Master/slave mode is determined
by CSEL if S1 is shorted (jumper set). In this case S2 and S3 are
irrespective for setting the mode.
Note:
When setting modes using these straps, be sure to switch off the
CD-RW drive before doing so.
Remark:
X: Strap shorted
–: Strap open
S1
S2
S3
Remarks
X
–
–
CSEL
. Master or Slave drive is set by using
CSEL terminal. (DASP signal is used to
recognize slave drive. If slave is absent, the
shadow register is used.)
–
X
–
Slave
–
–
X
Master
(DASP signal is used to recognize
slave drive. If slave is absent, the shadow
register is used.).