TEAC NT-505 Owners Manual English Francais Espanol - Page 3

VVPrecautions concerning batteries Model for Canada Misuse of batteries could cause them to rupture or leak leading to fire, injury or the staining of nearby things. Please read and observe Industry Canada's Compliance Statement: the following precautions carefully. This Class B digital apparatus complies with Canadian ICES-003. EN oo Be sure to insert the batteries with correct positive (¥) and negative (^) orientations. For European Customers oo Use batteries of the same type. Never use different types of batteries together. oo If the remote control is not used for a long time (more than a month), remove the batteries to prevent them from leaking. oo If the batteries leak, wipe away the leakage inside the battery compartment and replace the batteries with new ones. oo Do not use batteries of types other than those specified. Do not mix new batteries with old ones or use different types of batteries together. oo Do not heat or disassemble batteries. Never throw batteries into fire or water. oo Do not carry or store batteries with other metallic objects. The batteries could short circuit, leak or explode. oo Never recharge a battery unless it is confirmed to be a rechargeable type. Model for USA Declaration of Conformity Pioneer & Onkyo U.S.A. Corporation Address: 22828 Lockness Avenue, Torrance, CA 90501 U.S.A. Telephone number: 1-201-785-2600 This device complies with Part.15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Disposal of electrical and electronic equipment and batteries and/or accumulators a) All electrical/electronic equipment and waste batteries/ accumulators should be disposed of separately from the municipal waste stream via collection facilities designated by the government or local authorities. b) By disposing of electrical/electronic equipment and waste batteries/accumulators correctly, you will help save valuable resources and prevent any potential negative effects on human health and the environment. c) Improper disposal of waste electrical/electronic equipment and batteries/accumulators can have serious effects on the environment and human health because of the presence of hazardous substances in the equipment. d) The Waste Electrical and Electronic Equipment (WEEE) symbols, which show wheeled bins that have been crossed out, indicate that electrical/electronic equipment and batteries/accumulators must be collected and disposed of separately from household waste. If a battery or accumulator contains more than the specified values of lead (Pb), mercury (Hg), and/or cadmium (Cd) as defined in the Battery Directive (2006/66/EC, 2013/56/EU), then the chemical symbols Pb, Hg, Cd for those elements will be indicated beneath the WEEE symbol. e) Return and collection systems are available to end users. For more detailed information about the disposal of old electrical/electronic equipment and waste batteries/accumulators, please contact your city office, waste disposal service or the shop where you purchased the equipment. Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the equipment and/or the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. The nameplate is located on the bottom of the unit as shown below. Front side Nameplate • Consult the dealer or an experienced radio/TV technician for help. CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 3