TEAC PDH600 Owners Manual - Page 19

ENGLISH Troubleshooting Specifications If you have any problems with the unit, please take a moment to look through this chart and see if you can solve the problem yourself before you call your dealer or a TEAC service center. No power. e Check the connection to the AC power source. Check and make sure the AC source is not a switched outlet and if it is, the switch is turned on. Make sure there is power to the AC outlet by plugging another item such as a lamp or fan. e While the system control function is activated, turn on the unit using the remote control unit (RC-1181) of the AG-H600 series receiver. e When you do not use the system control function, set the SYSTEM CONTROL SELECTOR switch to "SINGLE". No sound. e Check the connection to the amplifier/receiver. e Check the operation of the amplifier/receiver. Remote control doesn't work. e If the batteries are exhausted, change the batteries. e Use remote control unit within the range (5m) and point at the front panel. e Make sure that there are no obstacles between the remote control unit and the main unit. e If a fluorescent light is near the unit, turn it off. e While the system control function is activated, the STANDBY/ ON button on the remote control unit of this unit does not work. Use the same button on the remote control unit (RC1181) of the AG-H600 series receiver. Frequency Response 20 Hz - 20 kHz, ±0.5 dB Total Harmonic Distortion (at 20 kHz LPF) Less than 0.003 % (1 kHz) Signal-to-Noise Ratio (S/N) (at 20 kHz LPF) More than 110 dB (1 kHz, 0 dB, A weight) Output Analog: 2.0 Vrms (RCA, 1 kHz, 0 dB) Digital: RCA COAXIAL (0.5 V, 75 Ω) Power Requirement AC 230 V, 50 Hz Power Consumption 9 W Dimensions (W x H x D 290 x 102 x 308 mm Weight (Net 5.4 kg Accessories RCA cable x 1 System control connection cord x 1 Power cord x 1 Remote control unit (RC-1182) x1 Batteries (AAA) x2 Owner's manual x1 Warranty card x1 < Design and specifications are subject to change without notice. < Weight and dimensions are approximate. < Illustrations may differ slightly from production models. Cannot play. e Load a disc with the playback side facing down. e A blank disc may be loaded. Load a prerecorded disc. e Depending on the disc, etc. it may not be possible to play back CD-R/CD-RW discs. Try again with another disc. e You cannot play back unfinalized CD-R/CD-RW discs. Finalize such a disc in a CD recorder and try again. Sound skips. e Place the unit on a stable place to avoid vibration and shock. e If the disc is dirty, clean the surface of the disc. e Do not use scratched, damaged or warped discs. Cannot programmed play. e If the unit turns off or the disc tray is opened, the programmed contents are cleared. No display. e Set the dimmer setting to "NORMAL" or "DIMMER". e Change the source to CD on the AG-H600 series receiver. e While Tone Direct is active on the AG-H600 series receiver, the display is turned off. If normal operation cannot be achieved, unplug the power cord from the outlet and plug it again. 19