TEAC PDH600 Owners Manual - Page 9
White L, Red R, ENGLISH - reference
View all TEAC PDH600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
ENGLISH A LINE OUT jacks These jacks transmit an analog 2-channel audio signal. Connect them to the CD jacks of a receiver or an amplifier with the provided RCA cables. < Make sure to connect the cables as follows: White plug q White jack (L: left channel) Red plug q Red jack (R: right channel) White (L) Red (R) White (L) Red (R) < Be sure to insert each plug securely. To prevent hum and noise, avoid bundling the signal interconnection cables together with the AC power cord or speaker cables. E SIGNAL GND terminal Connect the signal ground of other components using a commercially available jacketed cable (PVC-covered cable or others). < Note that this is NOT an electrical safety ground (earth). F AC Inlet Use only the supplied power cord. < Use of other power cord may result in fire or electric shock. < Unplug the power cord when you are not going to use the unit for an extended period of time. B DIGITAL OUT jack Connect it to a digital coaxial input terminal of a digital apparatus such as a CD recorder with a commercially-available digital coaxial cable. < Make sure that the cable is firmly inserted. C SYSTEM CONTROL jack If you have TEAC AG-H600 series receiver, convenient system control functions are available. Connect it to the SYSTEM CONTROL jack on the AG-H600 series receiver with the provided system control connection cord. Then set the SYSTEM CONTROL SELECTOR switch on this unit to "SYSTEM". (See D .) Available system control functions are as follows: N When you turn on or standby the AG-H600 series receiver using the remote control unit (RC-1181) of the receiver, this unit is also turned on or standby synchronously. N When you change the source from CD to another on AG-H600 series receiver, playback stops and display turns off on this unit. Refer also to the manual of the AG-H600 series receiver. D SYSTEM CONTROL SELECTOR switch When you want to use the system control functions, connect the SYSTEM CONTROL jacks (see C ), and set the switch to "SYSTEM". < The STANDBY/ON button on the remote control unit of this unit does not work while the switch is set to "SYSTEM". < When you do not use the system control functions or do not have a AG-H600 series receiver, set the switch to "SINGLE". Otherwise, you cannot turn on or standby the unit. 9