TEAC W-890R Manual for W-890R - Page 8
Features of the W-890R, Front panel - b audio cassette tape deck
View all TEAC W-890R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Front panel Features of the W-890R POWER switch This switches the unit power between off and on. NOTE The apparatus draws nominal non-operating power from the AC outlet with its POWER in the off position. TAPE I compartment RTZ key (TAPE I only) This key returns the tape to the counter zero point. COUNTER RESET keys Pressing these keys reset the tape counter readings for TAPE I and TAPE II, respectively. Synchro reverse key (SYNC REVERSE) Pressing this key activates the synchro reverse dubbing function. REPEAT key This allows repeat playback of a selected section of the tape. Display This shows tape counters, level meters, etc. Parallel record key (PARALLEL REC) This key lets you simultaneously record on both decks. Dubbing start key (DUB START) This key is used when copying the contents of a tape from TAPE I to TAPE II, either at normal or high speed. TAPE II compartment I Reverse mode switch (REV MODE) This switch is used to switch between reverse modes. O TIMER switch This switch is provided for use with a commercially available audio timer, to allow timer controlled recording or playback. Normally, leave this switch to the OFF position. = DOLBY NR switch This switch toggles the Dolby Noise Reduction system on/off. In playback you need to set this switch to the same position as when the recording was made. J EJECT ( ) keys Pressing these keys opens the TAPE I and TAPE II compartments. L MIC jack and level control Insert your microphone into this jack and use the knob to adjust the level of mic input. NOTE The MIC jack is mono. You cannot use a stereo microphone with this cassette deck. Q Headphones jack (PHONES) Plug your headphones into this jack. M PITCH CONTROL This control is used to vary the playback speed. A REC LEVEL This control is used to adjust the recording level. 8