TP-Link T3700G-52TQ T3700G-52TQUN V1 CLI Reference Guide Guide - Page 258

T3700G-52TQ JetStream 52-Port Gigabit Stackable L3 Managed Switch CLI Guide portfast -- Enable/ Disable Edge Port. By default, it is disabled. The edge port can transit its state from blocking to forwarding rapidly without waiting for forward delay. point-to-point -- The P2P link status, with auto, open and close options. By default, the option is auto. If the two ports in the P2P link are root port or designated port, they can transit their states to forwarding rapidly to reduce the unnecessary forward delay. Command Mode Interface Configuration Mode (interface fastEthernet / interface range fastEthernet / interface gigabitEthernet / interface range gigabitEthernet / interface ten-gigabitEthernet / interface range ten-gigabitEthernet / interface port-channel) Example Enable the STP function of Gigabit Ethernet port 1/0/1, and configure the Port Priority as 64, ExtPath Cost as 100, IntPath Cost as 100, and then enable Edge Port: T3700G-52TQ(config)#interface gigabitEthernet 1/0/1 T3700G-52TQ(config-if)#spanning-tree common-config port-priority 64 ext-cost 100 int-cost 100 portfast enable point-to-point open 30.4 spanning-tree mode Description The spanning-tree mode command is used to configure the STP mode of the switch. To return to the default configurations, please use no spanning-tree mode command. Syntax spanning-tree mode {stp | rstp | mstp} no spanning-tree mode Parameter stp -- Spanning Tree Protocol, the default value. rstp -- Rapid Spanning Tree Protocol mstp -- Multiple Spanning Tree Protocol 235