TP-Link TL-SG1024S Unmanaged/Easy Smart Rackmountable Switch Installation Guid - Page 12

Unmanaged/Easy Smart Rackmountable Switches 10/100/1000Mbps RJ45 Port Designed to connect to the device with a bandwidth of 10 Mbps, 100 Mbps or 1000 Mbps. For TL‑SG1008MP and TL‑SG1016PE, port 1-8 can provide power for PDs. For TL-SG1218MP and TL-SG1218MPE, port 1-16 can provide power for PDs. For TL-SG1428PE, port 1-24 can provide power for PDs. 10/100Mbps RJ45 Port Designed to connect to the device with a bandwidth of 10 Mbps or 100 Mbps. SFP Port Designed to install the SFP module. TL-SG1218MP/TL-SG1218MPE/TL-SG1428PE has 2 SFP ports which support 1000 Mbps SFP module connection. For TL-SG1218MP and TL-SG1218MPE, an SFP Port (port 17F/port 18F) and the associated 10/100/1000 Mbps RJ45 Port (port 17/port 18) are called a "Combo" port, which means they cannnot be used simultaneously; otherwise, only the SFP port works. ■■ Rear Panel The rear panel is shown as the following figure. Here we take TL-SG1016PE as an example. Figure 1-21 Rear Panel Kensington Security Slot Power Socket Grounding Terminal Kensington Security Slot Secure the lock (not provided) into the security slot to prevent the device from being stolen. Note: Only TL-SG1016PE/TL-SG1218MP/TL-SG1218MPE/TL-SG1428PE has a kensington security slot. Grounding Terminal The switch already comes with lightning protection mechanism. You can also ground the switch through the PE (Protecting Earth) cable of AC cord or with Ground Cable. For detailed information, refer to the Lightning Protection Guide from the Related Documents of our website: https://www.tp-link.com/us/configuration-guides/lightning_protection_guide. Power Socket Plug the female connector of the power cord directly into the power socket and plug the male connector into an AC outlet. Make sure that the voltage of the power supply meets the requirement of the input voltage (100-240 V ~ 50/60 Hz). Caution: You should use the provided power cord. 8 Introduction