TP-Link TL-SG2424 TL-SG2424 v1 User Guide - Page 13
Rear Panel, Reset, 100/1000Mbps Ports, SFP Ports, Speed and Duplex, Switching, Port Config - factory reset
View all TP-Link TL-SG2424 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Figure 2-2 Front Panel of TL-SG2424 The following parts are located on the front panel of the Switch: Reset: Press this button for five seconds or above to reset the software setting back to factory default setting. 10/100/1000Mbps Ports: Designed to connect to the device with a bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each has a corresponding 1000Mbps LED and link/Act LED. SFP Ports: Designed to install the SFP module. The SFP ports share the same LEDs with the corresponding RJ45 ports, and they are referred to as "combo" ports, which means they cannot be used simultaneously, otherwise only SFP ports work. Note: When using the SFP port with a 100Mbps module or a gigabit module, you need to configure its corresponding Speed and Duplex mode on Switching→Port→Port Config page. For 100M module, please select 100MFD while select 1000MFD for gigabit module. By default, the Speed and Duplex mode of SFP port is 1000MFD. LEDs Name Power System 1000Mbps Link/Act Status On Flashing Off On Flashing Off On Off On Flashing Off Indication Power is on. Power supply is abnormal. Power is off or power supply is abnormal. The Switch is working abnormally. The Switch is working normally. The Switch is working abnormally. A 1000Mbps device is connected to the corresponding port. A 10/100Mbps device or no device is connected to the corresponding port. A device is connected to the corresponding port but no activity. Data is being transmitted or received. No device is connected to the corresponding port. 2.3.2 Rear Panel The rear panel of TL-SG2216/TL-SG2424 features a power socket and a Grounding Terminal (marked with ). 6