TP-Link TL-WPA4226T KIT TL-PA4020P V1 User Guide - Page 14

Hardware Connection – Internet

Get TP-Link TL-WPA4226T KIT PDF manuals and user guides View all TP-Link TL-WPA4226T KIT manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

TL-PA4020P AV500 2-port Powerline Adapter with AC Pass Through 2.4 Hardware Connection - Internet This section describes how to connect the Powerline Adapter into your existing ADSL broadband connection via ADSL Ethernet port. Follow the procedures described below to connect the Powerline Adapter to your ADSL broadband connection: 1．Connect one end of the provided Ethernet (RJ45) cable to the Powerline Adapter's Ethernet port. 2．Connect the other end of the Ethernet (RJ45) cable to an available Ethernet port of your ADSL broadband Router. 3．Plug the Powerline Adapter into a wall socket next to the computer. 4．Turn on your computer. 5．Check and confirm that the Power LED , Ethernet LED Powerline Adapter are ON. The hardware connection mechanism is shown below: , and Powerline LED on the ) Note: Where the MAINS plug or an appliance coupler is used as the disconnected device, the disconnect device shall remain readily operable. The idle wall sockets or electrical outlets in your household electrical circuit can be used normally without interference from the network. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
TL-PA4020P
AV500 2-port Powerline Adapter with AC Pass Through
8
2.4 Hardware Connection – Internet
This section describes how to connect the Powerline Adapter into your existing ADSL broadband
connection via ADSL Ethernet port. Follow the procedures described below to connect the Powerline
Adapter to your ADSL broadband connection:
1
．
Connect one end of the provided Ethernet (RJ45) cable to the Powerline Adapter’s Ethernet port.
2
．
Connect the other end of the Ethernet (RJ45) cable to an available Ethernet port of your ADSL
broadband Router.
3
．
Plug the Powerline Adapter into a wall socket next to the computer.
4
．
Turn on your computer.
5
．
Check and confirm that the Power LED
, Ethernet
LED
, and Powerline LED
on the
Powerline Adapter are
ON
.
The hardware connection mechanism is shown below:
)
Note:
Where the MAINS plug or an appliance coupler is used as the disconnected device, the disconnect
device shall remain readily operable. The idle wall sockets or electrical outlets in your household
electrical circuit can be used normally without interference from the network.