TRENDnet TEW-453APB Quick Installation Guide - Page 4

2. Install Hardware 1. Locate an optimum location for the Access Point. The best place for the Access Point is usually at the center of your wireless network. 2. Connect the RJ45 network cable to the Access Point, then connect the other end of the network cable to a Switch or Hub. The Access Point is now connected to your 10/100mbps network. 3. Connect the power adapter to the Access Point. Make sure you use the power adapter supplied with the Access Point; using a different power adapter may damage the unit. TEW-453APB 2 3 2 NOTE: If you are using a wired computer to configure the Access Point, please connect this computer to the same Switch or Hub the TEW-453APB is connected to. LAN POWER Wireless Verify Hardware Installation Make sure the front panel lights are on: Power, LAN, Wireless. 2 English