TRENDnet TPL-303E Quick Installation Guide - Page 8

Troubleshooting 1. I inserted the TPL-303E/TPL-303E2K CD-ROM into my computer's CD-ROM Drive and the installation menu does not appear automatically. What should I do? 1. For Windows 7, if the installation menu does not appear automatically, click on the Windows Icon on the bottom left hand corner of the screen,, click the "Search programs and files" box, and type D:\autorun.exe, where "D" in "D:\autorun.exe" is the letter assigned to your CD-ROM Drive, and then press the ENTER key on your keyboard 2. For Windows Vista, if the installation menu does not appear automatically, click Start, click the Start Search box, and type D:\autorun.exe where "D" in "D:\autorun.exe" is the letter assigned to your CD-ROM Drive, and then press the ENTER key on your keyboard. 3. For Windows XP, if the installation menu does not appear automatically, click Start, click Run, and type D:\autorun where "D" in "D:\autorun.exe" is the letter assigned to your CD-ROM Drive, and then press the ENTER key on your keyboard. 2. I have verified that my Powerline device is connected to my workstation, but I cannot detect other Powerline devices. What should I do? 1. Verify that you are using Cat 5e or Cat. 6 Ethernet cables. 2. Press the Sync button on your TPL-303Es for 3 seconds then let go. 3. Open up the 200Mbps Powerline Utility and click scan. 4. Verify the network name of your Powerline network. Then go to the Privacy tab in the 200Mbps Powerline Utility, type in the network name and click Set Local Device Only. 5. Verify that the power outlet the TPL-303E is plugged into is on the same electrical power distribution and/or circuit breaker box. 6. Reset your TPL-303Es. Take a pin or paperclip and press the reset button for 15 seconds. The reset button is located on the side of the TPL-303E. 3 I can detect my Powerline devices on my Powerline network, but I cannot connect to the Internet. What should I do? 1. Make sure you are not connecting the device into a surge protector. 2. Make sure that your Router is connected to the Internet. 3. Make sure your TCP/IP settings are set to Obtain an IP address automatically (see the steps below). Windows 7 1. Go into the Control Panel, click Network and Internet, click Network and Sharing Center, click Change Adapter Settings and then rightclick the Local Area Connection icon and then click Properties. 2. Click Internet Protocol Version 4(TCP/IPv4) and then click Properties. Then click on Obtain an IP address automatically. 6