Thermador MC30WS Installation instructions - Page 10
Install Appliance, Testing Operation
View all Thermador MC30WS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Three-wire Connection SRZHUVXSSO\ MXQFWLRQER[ UHGZLUHV ZKLWHEDUHRU JUHHQZLUH ZKLWHZLUH JUHHQZLUH EODFNZLUHV 8/OLVWHG FRQQHFWRU FDEOHIURP RYHQ ▯ Connect red wire from oven to red wire in junction box. ▯ Connect black wire from oven to black wire in junction box. ▯ Connect both green ground wire and white wire from oven to white, green or bare neutral wire in junction box. The conduit cable, where connected at the oven, swivels. Rotate conduit cable upward (or downward) and direct through hole prepared in cabinet to attach to junction box. To maintain serviceability, the flex conduit must not be shortened and should be routed to permit temporary removal of the oven. Install Appliance Note: The appliance is heavy. It is advisable to install it with a second person. NOTICE: Before installing the appliance, be sure to verify the cabinet dimensions and electrical connections. Mount to Cabinet 1. Fully insert the appliance and center it. Do not kink the electrical cable. 2. Screw the appliance into place. Testing Operation 1. Turn on power at the breaker. 2. Check power at junction box using a volt meter. For 240 V installation, the reading between the red and black wires (line to line) should be 220 to 240 volts. For 208 V installation, the reading between the red and black wires (line to line) should be 190 to 208 volts. 3. Test the oven mode: Select "True Convection" mode. See the Use and Care Guide for detailed instructions on how to do this. NOTICE: Never run the microwave unless there is food or water in the oven cavity. 4. Verify that the oven light comes on and the oven begins to preheat. 5. Test the microwave: Place a cup of water into the oven cavity. Follow the instructions in the Use and Care Guide on how to heat a beverage. 6. Verify that the oven light comes on and the water is heated. 7. If any of the tests do not result as explained above, contact Service for assistance. Otherwise, the installation is complete at this time. 10