Thermador PCG486GD Installation Instructions PART3 - Page 4
Safety Instructions - conversion kit
View all Thermador PCG486GD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Safety Instructions Important Safety Instructions READ AND SAVE THESE INSTRUCTIONS APPROVED FOR ALL RESIDENTIAL APPLIANCES FOR RESIDENTIAL USE ONLY AND GROUNDING MUST COMPLY WITH ALL APPLICABLE CODES. Electrical Power Supply Before you Begin IMPORTANT: Save these Instructions for the Local Electrical Inspector's use. INSTALLER: Please leave these Instructions with this unit for the owner. OWNER: Please retain these instructions for future reference. WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to this manual. For assistance or additional information consult a qualified installer, service agency, manufacturer (dealer) or the gas supplier. NOTE: This Cooktop is NOT designed for installation in manufactured (mobile) homes or for installation in Recreational Park Trailers. DO NOT install this appliance outdoors. Data Rating Plate Cooktop Models: The data rating plate showing the model and serial numbers of your cooktop is located on the underside of the cooktop chassis near the gas inlet connection and electric power cord. This information is required if customer service is requested. Before installation, the model and serial numbers should be entered in the appropriate spaces in the "BEFORE CALLING FOR SERVICE" section near the back of the Care and Use Manual. After installation, accessing the information is difficult. PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING IMPORTANT: LOCAL CODES VARY. INSTALLATION, ELECTRICAL CONNECTIONS, GAS CONNECTIONS, English 2 30'' Model: 4 Burners - 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit 36" Models: 6 Burners - 120 VAC, 60 Hz., 1 Ph., 10 Amp circuit 4 Burners with Electric Griddle - 120 VAC, 60 Hz., 1 Ph., 15 Amp circuit 48" Model: 6 Burners with Electric Griddle - 120 VAC, 60 Hz., 1 Ph., 15 Amp circuit Gas Supply Natural Gas - 6" min. to 14" max. water column (14.9 mb to 34.9 mb) Propane Gas - 11"min. to 14"max. water column (27.4 mb to 34.9 mb) WARNING Disconnect power before installing. Before turning power ON, be sure that all controls are in the OFF position. All sealed burners are rated at 18,000 BTU/HR (*15,000 BTU/HR on LP). *All models are convertible to LP/Propane gas using an accessory conversion kit. IMPORTANT • A backguard must be utilized when there is less than a 12" horizontal clearance between combustible materials and the back edge of the cooktop. The Thermador Low Back backguard must be ordered separately and installed at the rear of the cooktop. For island installations and other installations with more than 12" clearance, an optional stainless steel Island Trim is available to cover the backguard mounting flanges. • Verify that the appliance is correct for the type of gas being provided. Refer to "Step 4: Gas Requirements and Hookup" on page 11 before proceeding with the installation.