Thermador PH36GWS Installation instructions - Page 17
Cabinet Installation, Blower Motor Installation
View all Thermador PH36GWS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Cabinet Installation Blower Motor Installation The hood can be installed under a cabinet by supporting the hood from the top. Note: The cabinet must be structurally joined to the wall studs to support the weight of this hood. Check the structural integrity of the cabinet/wall before proceeding. The figure shows the (4) screw holes labeled "K" used for mounting the hood to the bottom of the cabinet. Make sure both knockouts have been removed (see "Prepare for the wire routing" on page 16). L x2 A 19/16" K x4 (40) L 71/16" (179) Hood Size 30'' (762 mm) 36'' (914 mm) 42'' (1,067 mm) 48'' (1,219 mm) 54'' (1,372 mm) 60'' (1,524 mm) inches (mm) A 29'' (737 mm) 35'' (889 mm) 41'' (1,041 mm) 47'' (1,194 mm) 53'' (1,346 mm) 59'' (1,499 mm) 1. In the base of the cabinet, drill 1/8'' (3 mm) tap holes spaced as indicated by Dimension A. 2. Screw in (4) 1" (25 mm) screws (provided with hood) leaving 1/4'' (6 mm) exposed to hang hood on. 3. If the hood is installed for vertical discharge, refer to "Vertical Discharge Transition" on page 13 to create clearance holes for passage of the transition and conduit. 4. For horizontal discharge, use See "Horizontal Discharge Transition" on page 13. for the geometry of the cutout required for clearance of the transition. 5. Hang hood from screws and tighten securely. 6. From inside of hood, insert screws supplied. Drill through holes, use 5/8'' (16 mm) screws supplied, (1) on each side and (4) along the front, into bottom of the cabinet. See screw holes labeled "L" in figure. Blower and Circuit Breaker Ratings Blower SKU Remote Remote Remote In-line In-line Integral Integral VTR630 VTR1030 VTR1330 VTI610 VTI1010 VTN630 VTN1090 Voltage Current Breaker Amp 120 4.2 15 120 5.7 15 120 8.5 15 / 20 120 4.2 15 120 5.7 15 120 4.2 15 120 5.4 15 9 CAUTION To reduce the risk of fire and electric shock, install this range hood only with the blowers listed in the Ventilation Planning Guide. NOTE: Cutting the plug of the blower will void the warranty or eligibility for return or exchange. All blower models are sold separately. Use only Thermador blowers with these ventilation hoods. See the Ventilation Planning Guide for recommended blowers. Contact Customer Service for additional options. All hood models are rated for 120V AC installed with a blower listed in the table above, using a 15 amp dedicated circuit breaker. The VTR1330 blower in conjunction with a PHxxGWS requires a 20 amp circuit breaker. Blower selection will vary based on the volume of air that needs moved and the length and location of the duct run. For long duct runs with multiple turns and bends, consider using a more powerful blower. For the most efficient air flow exhaust, use a straight run or as few elbows as possible (refer to "Ductwork Preparation"). Integral Blower Installation Integral Blower models are integrated into the hood at the time of installation. Integral Blowers should be installed after the hood is mounted to the wall. Page. 17