Toshiba 32A61 Owners Manual - Page 13

Welcome to Toshiba Connecting your TV Using the Remote Control Setting up your TV Using the remote control Preparing the remote control for use The remote control will operate your TV, most VCR models, and most cable TV converters together, even if they are different brands. If you will be using your TV with a Toshiba VCR, your remote control is already programmed and ready to use. If you own different brands of VCRs and/or converters, you will need to program your remote control (see "Programming the remote control for use with a VCR or cable TV converter" on page 8). Installing the remote control batteries To install the batteries: 1. Slide the battery cover off the back of the remote control. 2. Install two "AA" size batteries. Match the + and - symbols on the batteries to the symbols on the battery compartment. Note: The remote control provided with your TV may or may not operate certain features on your VCR, cable TV converter, or other electronic components. Refer to the owner's manuals provided with your other components to see which features are available. In addition, the other remote controls may have buttons not available on your TV's remote control. If you would like to use those features or buttons, you may need to use the original remote controls for your other components. Caution: • Dispose of batteries in a designated disposal area. Do not throw batteries into a fire. • Do not mix battery types or combine used batteries with new ones. • Remove dead batteries immediately to prevent battery acid from leaking into the battery compartment. • If you do not intend to use the remote control for a long time, remove the batteries. 3. Slide the battery cover back onto the remote control until the lock snaps. Using the remote control with a VCR or cable TV converter To control a Toshiba VCR: Set the TV/CABLE/VCR switch to the VCR position. The shaded buttons in the illustration at right will then control the VCR. The unshaded buttons will operate the TV as usual. To control a cable TV converter: Program the remote control to recognize the brand of your converter (see "Programming the remote control for use with a VCR or cable TV converter" on page 8). Set the TV/CABLE/ VCR switch to the CABLE position. The shaded buttons in the top portion of the illustration at right will then control the cable TV converter. LIGHT RECALL POWER TV CABLE VCR MUTE TV/VIDEO TIMER 12 45 3 CH 6 78 9 VOL CH RTN 100 0 ENT ADV/ PIP CH RECALL POWER TV/CABLE/VCR switch CH (Channel) Channel Numbers ENT (used for the "ENTER" command with some VCRs and cable TV converters) FAV ENTER FAV C.CAPT EXIT MENU RESET ADV/ PIP CH STOP SOURCE PLAY PIP REC TV/VCR REW FF STILL LOCATE SWAP CT-9946 STOP PLAY FAST FORWARD REWIND TV/VCR RECORD Note: Some cable/TV converters may require the ENT key to be pressed after pressing channel numbers. (i.e. 0 - 2 - ENT) Using the TV's Features Appendix Index Reference 13