Toshiba 32A61 Owners Manual - Page 19

Welcome to Toshiba Connecting your TV Using the Remote Control Using the TV/VIDEO button You can monitor or change the signal source that is connected to the TV. By pressing the TV/VIDEO button on the TV, you can select the VIDEO 1, VIDEO 2, ColorStream, ANT 1 or ANT 2 mode. The signal source you are currently connected to will be displayed in purple. To select the antenna input: 1. Press the TV/VIDEO button on the TV. The signal source you are connected to is displayed in purple. TV VIDEO 1 ANT 1 VIDEO 2 ANT 2 COLOR STREAM TO SELECT PUSH TV/VIDEO 2. Press the button until ANT 1 or ANT 2 is displayed in purple, indicating the antenna terminal you wish to use. Adding channels to the TV's memory Your TV will stop on specific channels that are stored in the TV's channel memory when you press Channel L or M. Use the steps below to set all active channels in your area automatically. Programming channels automatically Your TV can automatically detect all active channels and store them in its memory. After the TV has stored the channels in its memory, you can erase channels or add your favorite channels. If you use both ANT-1 and ANT-2 terminals, you must program channels for each input source. To add channels: 1. Press MENU, then press x or • to highlight the SET UP menu. 2. Press y or z until the TV/CABLE selection is highlighted. 3. Press x or • to highlight either TV or CABLE, depending on which you use. TV/VIDEO MENU TV / VIDEO VOLUME CHANNEL POWER LIGHT RECALL POWER TV CABLE VCR MUTE TV/VIDEO TIMER 12 45 3 CH 6 78 9 VOL CH RTN 100 0 ENT ADV/ PIP CH MENU C.CAPT EXIT MENU RESET FAV ENTER FAV ADV/ PIP CH EXIT Setting up your TV Using the TV's Features Appendix PICTURE AUDIO SET UP PREFER C.CAPT LANGUAGE: ANT1/2: TV/CABLE: CH PROGRAM ADD/ERASE: MORE SELECT[ ] [ENGLISH]FRANCAIS ESPANOL [ANT1]ANT2 [TV]CABLE [ADD]ERASE If you use an antenna, choose TV. If you use cable, choose CABLE. 4. Press z to select CH PROGRAM. 5. Press x or • to start channel programming. The TV will automatically cycle through all the TV or Cable channels (depending on which you selected), and store all active channels in the channel memory. While the TV is cycling through the channels, the message "CH PROGRAM" appears. 6. When channel programming is complete, the message "CH Completed (channel or cable number)" appears. 7. Press Channel L or M to view the programmed channels. 19 Index Reference