Toshiba 32AV500U Owner's Manual - English - Page 41

Chapter 6: Using the TV's features • H-Position: Moves the picture left/right. The adjustment range is -50~+50 (default value is 0).* • V-Position: Moves the picture up/down. The adjustment range is -10~+10 (default value is 0).* • Clock: Helps to reduce noise and sharpen the picture. The adjustment range is -10~+10 (default value is 0).* • Phase: Helps to reduce noise and minimize periodic vertical stripes on the screen. The adjustment range is -15~+16 (default value is 0).* * The default settings may vary depending on the input signal format. Setting the PC Audio If the INPUT source is set to PC. The PC IN audio phone jack is applied for PC IN when PC IN terminal is connecting with an analog RGB cable. ( page 19) Setting the sleep timer You can set the sleep timer to turn off the TV after a set length of time (maximum of 90 minutes). To set the sleep timer using the remote control: Press on the remote control to set the length of time until the TV turns off. Repeatedly press to increase the time in 30-minute increments, to a maximum of 90 minutes. To set the sleep timer using the on-screen menus: 1� Press and open the Prefer menu. 2� Highlight Sleep Timer. 3� Press u or to increase the time in 30-minute increments. Off30 Min60 Min90 MinOff Note: When a power failure occurs, the sleep timer setting may be cleared. Note: Because the PC Audio input is shared with HDMI 1. If INPUT source is set to "HDMI 1,"And the HDMI 1 signal is DVI format. This PC Audio input will apply for HDMI 1. (Also see item 2 on page 11.) To display the remaining sleep timer: Press on the remote control or same as above process using the on-screen menus. To cancel the sleep timer: Repeatedly press until it is set to Off. 41