Toshiba 36AFX61 Owners Manual - Page 23

Introduction Connecting your TV Using the Remote Control Adding channels to the TV's memory When you press Channel y or z, your TV will stop only on the specific channels stored in the TV's channel memory. Follow the steps below and on the next page to program channels into the TV's memory. Programming channels automatically Your TV can automatically detect all active channels in your area and store them in its memory. After the channels are stored automatically, you can manually add or erase individual channels. If you use both ANT-1 and ANT-2 input sources, you must program channels for each. To program channels automatically: 1. Press MENU, and then press x or • until the SET UP menu appears. 2. Press y or z until TV/CABLE is highlighted. 3. Press x or • to highlight either TV or CABLE, depending on which you use. If you use an antenna, highlight TV. If you use cable, highlight CABLE. SET UP LANGUAGE CLOCK SET ANT 1 / 2 TV / CABLE CH PROGRAM ADD / ERASE T I LT CORRECT I ON ENGL I SH ANT1 TV / CABLE ADD 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 4. Press z to highlight CH PROGRAM. SET UP LANGUAGE CLOCK SET ANT 1 / 2 TV / CABLE CH PROGRAM ADD / ERASE T I LT CORRECT I ON ENGL I SH ANT1 CABLE ADD 0 5. Press x or • to start channel programming. The TV will automatically cycle through all the TV or cable channels (depending on which you selected), and store all active channels in the channel memory. While the TV is cycling through the channels, the message "Programming Now-Please Wait" appears. 6. When channel programming is complete, the message "Completed" appears. 7. Press CH y or z to view the programmed channels. MENU yzx • CH yz Setting up your TV Using the TV's Features Appendix Index 32/36AFX61(E) 23