Toshiba 37AV502R Owner's Manual - English - Page 50

Chapter 6: Using the TV's features Other REGZA-LINK® functions When the Enable REGZA-LINK and each item in the REGZA-LINK Setup menu are set to On, the following functions will be enabled. Item Description TV Auto Input Switch If a connected HDMI device starts playing video or audio, the TV will automatically switch to the appropriate HDMI input. TV Auto If a REGZA-LINK device is turned on, the Power TV turns on automatically. Device Auto Standby If the TV is turned off the TV will send a message to turn off all of the REGZA-LINK devices connected to the TV. Speaker Preference From this item, you can set your audio output preference to the TV speakers or the audio receiver speakers. When this item is set to Audio Receiver, the TV remote can be used to adjust or mute the volume of the audio. This item will be grayed out unless a REGZALINK compatible audio receiver is connected. Note: When you turn on the Audio Receiver, change its input source, or adjust the sound volume, the sound will be output from the audio receiver's speakers even if TV Speakers has been selected. Turn the TV off and on again to output the sound from the TV speakers. To set the REGZA-LINK® Setup: 1� From the Setup menu, highlight REGZA-LINK Setup and press . � Press p or q to highlight Enable REGZA-LINK. � Press t or u to select On. Note: If you select Enable REGZA-LINK Off, the other items will be grayed out. � Press p or q to highlight the REGZA-LINK Setup item you want to use, and press t or u to select On or desired mode. • TV Auto Input Switch: On/Off • TV Auto Power: On/Off • Device Auto Standby: On/Off • Speaker Preference: TV Speakers/Audio Receiver � To save the new settings, highlight Done and press . To revert to the factory defaults, highlight Reset and press . 50 Displaying TV status information To display TV status information using RECALL: Press on the remote control. The following information will display (if applicable): • Current input (ANT/CABLE, VIDEO 1, etc.) • If ANT/CABLE is the current input, either "CABLE" (for cable TV) or "ANT" (for over-the-air broadcasts). • Channel number (if in ANT/CABLE mode) • Channel label (if set) • Digital signal strength indicator (bar graph in lower right corner of box; for ATSC signal only) • Stereo, Mono or SAP audio status (when HDMI input mode, Dolby Digital or PCM) • Video resolution • Aspect ratio of incoming video signal (4:3 or 16:9) • V-Chip rating status • Game Timer (if set) To close the RECALL screen: Press again. To display TV status information using INFO: Press on the remote control. The following additional information will display for off air digital channels (if applicable): • Title • Duration • Detailed description Note: The location of the banner can be moved to the top or bottom of the screen by pressing  or  while the RECALL or INFO display is on-screen. Understanding the auto power off feature The TV will automatically turn itself off after approximately 15 minutes if it is tuned to a vacant channel or a station that completes its broadcast for the day. This feature functions in ANT/CABLE mode only. Understanding the last mode memory feature If the power is cut off while you are viewing the TV, the Last Mode Memory feature automatically turns on the TV when the power is resupplied. Note: If it's possible, and you will be away from the TV for an extended period of time you should unplug the power cord.