Toshiba BDX5200KU Owners Manual - Page 32

Function setup Customizing the Function Settings The symbols that might appear next to each listed wireless network in the network list are as follows: Category Icon Definition Connected When the Blu-ray Disc™ player is turned on, it will connect to the wireless network displaying this symbol. Typically, this is the last wireless network connected before powering down. Indicates that the Blu-ray Disc™ * player is currently connected to this network. Saved The wireless network properties have been saved in the Blu-ray Disc™ player's memory. Wireless Security The wireless network data is not encrypted. The wireless network data is encrypted; a 'security key' must be entered so that the Blu-ray Disc™ player can share data over the network. The wireless network data is encrypted; the encryption scheme is not supported by the Blu-ray Disc™ player. Wireless Protocol a The wireless network supports 802.11a b The wireless network supports 802.11b g The wireless network supports 802.11g n The wireless network supports 802.11n The wireless router supports the WPS standard. Signal Strength Strong Signal Good Signal Medium Signal 1. In the "Wireless" menu, press / to select Network List, then press OK. A list of existing wireless networks near the Blu-ray Disc™ player will appear (It may take several seconds for this list to be created). For example: Network List WiFi a WiFi-me* WiFi b g n Panda WiFi a WiFi b g WiFi b g dlink_media NTGR 11g Airport_SN 2. Press / to select the desired wireless network, and press OK to confirm. a. If the Blu-ray Disc™ player is connected to an Unencrypted Wireless Network, a menu similar to the following will appear: Connect WiFi-me WPS Pin Cancel Name and Password are case-sensitive 3. Press / to highlight Connect, and press OK. If the wireless network is functioning, icon and a message "Connection to XXX...Success" will appear on the TV. 4. Press OK to close the message. The Blu-ray Disc™ player is now connected to the network. From now on, when you turn on the player, it will automatically connect to the network; there is no need to repeat these steps again. Note: If you do not see this message, the Blu-ray Disc™ player was not able to connect to the network. b. If the Blu-ray Disc™ player is connected to an Encrypted Wireless Network, a menu similar to the following will appear: Weak Signal No Signal I. Connection to the wireless Network which you select WiFi-me Password Connect WPS Pin Cancel Press ENTER to open keyboard Password is case-sensitive 32 Wireless Network List WiFi Protected Setup (WPS) Manual IP Settings 3. Press OK(ENTER) to activate the on-screen keyboard. Carefully enter the network password by using the / / / to highlight the desired letter on the keyboard, and then pressing OK. (If you make a mistake, use the backspace key to erase the mistake.) 4. Use / / / to highlight Done on the upper-right corner of the keyboard, and press OK to remove the keyboard from the screen.