Toshiba D-RW2SU Owners Manual - Page 26

Connections RF modulator Connection If your TV has Antenna in jack only, it is still possible to connect this unit to your TV by using a Stereo Audio/Video RF modulator. In this case, follow the instructions below. 1) The antenna input jack of your TV may have been already occupied. If so, disconnect the RF cable from your TV, and then connect the RF cable to the ANTENNA IN jack of this unit. 2) Connect the ANTENNA OUT jack of this unit to your RF modulator (usually marked "ANT IN") by the RF cable. 3) Connect your RF modulator to your TV by another RF cable. 4) Connect the AUDIO/VIDEO output jacks of this unit to the AUDIO/VIDEO input jacks of your RF modulator by Audio/Video cables. 5) Set your RF modulator's channel 3/4 switch to either 3 or 4, whichever the TV channel is least used in your area. If your RF modulator has a Modulator/Antenna switch, set it according to your RF modulator's manual. 6) Turn on your TV and choose the same channel as you set the RF modulator's channel 3/4 switch to. For more details, follow the instructions supplied with the RF modulator. Cable TV Antenna signal (Back of this unit) IN OUT VIDEO IN IN L R ANTENNA AUDIO IN (L1) COMPONENT VIDEO OUTPUT S-VIDEO Y OUT PB/CB PR/CR VIDEO OUT L R AUDIO OUT Audio/Video cables (supplied) Turn on your TV and select channel 3 or 4. RF cable (supplied) Set channel 3 or 4. AC 120V ANT IN CHANNEL TO TV 3 4 AUDIO IN VIDEO IN RL STEREO AUDIO/VIDEO RF Modulator (commercially available) Antenna in jack RF cable (commercially available) (Back of TV) Note • The quality of picture may become poor if this unit is connected to an RF modulator. 26 EN $POOFDUJPO@6%JOEE