Toshiba TDP-T9 User Manual - Page 25

Turning the power off, Press the ON/STANDBY button., Press the ON/STANDBY button again. - problem

Get Toshiba TDP-T9 PDF manuals and user guides View all Toshiba TDP-T9 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 25 highlights

■ Turning the power off 1 Press the ON/STANDBY button. A message appears on the screen, confirming that you wish to shut off the power. This message will disappear after a moment. (This operation is no longer valid after the message disappears.) 2 Press the ON/STANDBY button again. The screen turns off, but the internal cooling fan continues to operate for a short. Then , the projector goes into standby mode. When cooling lamp After cooling complete POWER POWER FLASH A B C A During cooling, the Power indicator flashes. In this state, the power cannot be turned back on. If you are in a hurry, there is no problem with unplugging the power cord or turning off the main power switch in this state. B In standby mode Note • The projector consumes about 15W of power in standby. We recommend that you unplug the power cord if you will not be using the projector for an extended period. PRECAUTION • If the power cord is unplugged before cooling is complete, give the lamp time (about 5 minutes) to cool before plugging it back in. 26

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
26
■
Turning the power off
1
Press the ON/STANDBY button.
A message appears on the screen, confirming that you wish to shut off the power. This
message will disappear after a moment. (This operation is no longer valid after the
message disappears.)
2
Press the ON/STANDBY button again.
The screen turns off, but the internal cooling fan continues to operate for a short. Then
, the projector goes into standby mode.
When cooling lamp
After cooling complete
A
b
POWER
FLASH
POWER
A
During cooling, the Power indicator flashes. In this state, the power cannot be
turned back on.
If you are in a hurry, there is no problem with unplugging the power cord or turn-
ing off the main power switch in this state.
B
In standby mode
Note
• The projector consumes about 15W of power in standby. We recommend that you unplug
the power cord if you will not be using the projector for an extended period.
PRECAUTION
• If the power cord is unplugged before cooling is complete, give the lamp time (about 5
minutes) to cool before plugging it back in.