Toshiba TLP-WX2200U Owners Manual - Page 22

Using the menus (Continued) Default setting 2 menu Item Projection mode Description Sets projection mode in accordance with Placement Style. p.21 (Standard) (Rear) (Ceiling) (Rear ceiling) Fan mode Remote control Key lock Reset all Password Sets the cooling fan speed. Standard High When two or more projectors are used and controlled by the remote control respectively, this menu sets the code for the projector and the remote control. [ or : Enter setting mode] [ : Select from 1, 2, 3, 4] [ :Confirm] [ :Select OK to end] Press [Cancel] to return. Lock the control panel buttons. [ or : Enter setting mode] [ : Select On/Off] [ :Confirm] [ :Select OK to end] Press [Cancel] to return. Press . (The password and user logo are not reset.) Resets all adjustments and settings to their factory settings. Yes No Password setting p.32 Detailed description [Fan mode] Setting [Fan mode] to [High] increases the cooling fan speed. (The cooling fan noise gets louder.) Set this option to use the projector, for example, at high altitude (over 1,500 meters above sea level). • Do not set Fan mode to [High] when using the projector at a lower altitude. [Remote control] Sets a remote control code from 4 types. You can set each code respectively for up to 4 projectors. The factory setting is [1]. To switch codes, set the same code for the projector and the remote control. A remote control code is applied after the setting is done. • You cannot operate the remote control if the codes of the projector and the remote control do not match. Remote control code setting for remote control Remove the battery cover and set the same remote control code switch as the projector. p.16 p.17 (Use a screwdriver with thin tip to set.) [Key lock] Protect from operating errors by locking on the control panel buttons of the projector. (The remote control operations are available.) Control panel operations are locked after the setting is done, and accordingly operation with the control panel buttons is disabled. • To release the key lock, set the [Key Lock] to [Off] using remote control. Pressing the [RETURN] button on the projector for 10 seconds also sets the [Key Lock] to [Off]. (When operating the main unit, the 2 indicators of LAMP and TEMP light in orange for 3 seconds, and at the same time the projector beeps.) ■ Displaying Information (Status display) This displays information about the input signal, lamp use time, etc. "Yes": displayed, "No": not displayed Item Description Projector Input Input source name Mode name RGB input mode [Note 1] Resolution Resolution (in dots) Frequency Sync frequency Sync Sync signal polarity [Note 2] Signal format Y/PB/PR signal format Video mode Color method of video signal Lamp time Time of lamp use [Note 3] Lamp reset count The count for lamp replacement Total time The total time that this projector is used. Version Firmware version [Note 4] Computer Y/PB/PR Yes Yes Yes No Yes No Yes No Yes No No Yes No No Yes Yes Yes Yes Yes Yes Yes Yes Video Yes No No No No No Yes Yes Yes Yes Yes S-video Yes No No No No No Yes Yes Yes Yes Yes Notes 1: The mode of supported RGB signals p.52 is shown. 2: Sync signal polarity shown as P (positive) or N (negative) for [H/V]. 3: Displays [Lamp time] as a measure of when the lamp should be replaced. (Cannot be used as a counter of guaranteed lamp time.) Please replace the lamp after 2000 hours of use if [Lamp power] is set to [Standard], or after 3000 hours of use if [Lamp power] is set to [Low], consult with a dealer about getting replacement for lamp TLPLW11 (sold separately). 4: [Version] shows the version of the projector's internal control program. This version is referred to for customer service, etc. Note • The displayed information will not be refreshed if the status changes. To refresh the information, dismiss the display, then display it again. Operations 42 43