Toshiba UT1A1A010C6 User Guide - Page 38
EPO Port emergency power off, Network Transient Protector, Load Segments
View all Toshiba UT1A1A010C6 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
port cannot be used when using the USB port. The USB cable is a standard cable and may be purchased separately. 6.4 EPO Port (emergency power off) A customer-supplied switch located remotely may be used to open the EPO connection and force the UPS output receptacles to be switched off. The EPO function shuts down the equipment immediately. An EPO will not provide an orderly shutdown. The UPS will have to be manually restarted in order to regain power to the outlets. After an Emergency Power Off (EPO), do not reset the breaker until the UPS has been fully discharged. The UPS could be damaged if the unit is not fully discharged before the breaker is reset. 6.5 Network Transient Protector The network transient protector, located on the back panel, has both IN and OUT RJ45 10 baseT jacks and will protect a single network connector. Connect the input connector to the jack labeled IN, and the output connector to the jack labeled OUT. 6.6 Load Segments The sets of receptacles known as load segments provide organized shutdown and startup of the equipment. Less critical equipment can be turned off during power outages saving battery power for critical loads. The load group status can be viewed from the LCD display and can be changed if necessary. Load 10% 20% 30% 40% 50% 60% 70% 80% 90% 100% 1000 VA Backup (min) 150 56 38 30 23 19 15 12 10 7 1500 VA Backup (min) 80 37 21 19 18 15 13 11 8 6 2000 VA Backup (min) 150 68 38 26 19 14 11 9 7 6 3000 VA Backup (min) 80 40 25 19 15 12 9 8 6 5 16