Toshiba XM-7002B Product Specification - Page 25

7. Power Requirements 7.1. Source Voltage 7.1.1 Spike 7.1.2 Ripple +5 V +/-5 % (Operating) 100 mV (p-p) Max 100 mV (p-p) Max 7.2. Current Drain (Typ. Value) 7.2.1. Sleep(Minimum Current Mode) 7.2.2. Standby(Laser off,motor off) 7.2.3. Idle(Laser on,motor on) Start Position 7.2.4. Continuous Read(Audio/Data) Start Position 7.2.5. Average(20% Duty Random Access) 7.2.6. Maximum(100% Duty Random Access) 0.025 A 0.03 A 0.32 A 0.62 A (Max.24X) / 0.35 A (Max.10X) 0.64 A (Max.24X) / 0.34 A (Max.10X) 0.76 A ( Max.24X) / 0.44 A (Max.10X) 7.2.7. Peak in executing Access (With out Spike Current*) 7.2.8. Peak Current (With out Spike Current)* *Spike:Less than 1ms width current 1.4 A 1.5 A 8. Audio 8.1. Line Output ----- in case of the attenuator is set at 0 dB by the command ----- (1) Output Level 0.775 V (rms Typ)+/- 3 dB (2) Type Unbalanced (3) Output Impedance 2.2 kOHM (4) Load Impedance 47 kOHM (5) Frequency Response 20 Hz to 20 kHz +/- 3.0 dB.(at 47 kOHM Load) (6) Distortion 0.03 % Max. (at 1 kHz weighted 20 kHz LPF) (7) Signal to Noise Ratio 78 dB Typ (IEC 179 A-weighted) 8.1.1. Audio Cable (1) Capacitance (2) Length Unbalanced and shielded Less than 1000 pF Max. 3 m 21/27 XM-7002B Rev.1.0