Tripp Lite 5P1500 Eaton 5P UPS Installation and User Manual - Page 22
Maintenance
View all Tripp Lite 5P1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
5. Maintenance 5.1 Troubleshooting Operation status Batteries disconnected Overload End of battery life Possible cause The UPS does not recognize the internal batteries The batteries are disconnected Power requirements exceeds the UPS capacity (greater than 105 % of nominal) The end of the battery life is reached. Action If the condition persists, contact your service representative Verify that all batteries are properly connected. If the condition persists, contact your service representative. Remove some of the equipment from the UPS. The UPS continues to operate, but may shutdown if the load increases. The alarm resets when the condition becomes inactive. Contact your service representative for battery replacement. Event UPS fault An UPS event occurs Example: Remote Power OFF, the RPO contact has been activated to shutdown the UPS and now prevents restart. The UPS has an internal fault. Set the contact back to its normal position and press button to restart. The UPS does not protect the equipment anymore. Note: The alarm message and the UPS Serial Number, then contact your service representative. Page 22 620-00082-01-us (en)