Tripp Lite B022-U08-IP Owner's Manual for B022-U08-IP 1U Rack KVM Switch 93327 - Page 22

6. KVM Operation (continued) 6.6.6 Remote Control Panel When accessing connected computers over IP, a control panel appears in the lower-right corner of your screen. The remote control panel allows you to perform tasks and edit settings related to the remote session. The icons provided in the remote control panel are described in the following section. Hotkey Setup When the Hotkey Setup icon is clicked, a screen appears that lists various actions related to the keyboard, video and mouse that can be performed via hotkey commands. The actions that can be performed are listed on the left side of the screen, and the hotkey commands that invoke them are shown to the right. Configuring the Hotkeys If you find the default hotkey commands inconvenient, you can configure them by following these steps: 1. In the Hotkey Setup screen, highlight the action that you wish to edit. 2. Click the Start button. 3. Enter in the new hotkey combination. The name of each key appears in the Keys field upon being entered. 4. When you have finished entering the new hotkey command, click the Set button. 5. Click the Close button to exit the Hotkey Setup screen. Video Settings Clicking the Video Settings icon in the control panel brings up the Video Settings dialog box. This dialog box allows you to adjust the placement and picture quality of the remote screen on your monitor: The table describes the actions that are found in the Hotkey Setup screen: Action Hotkey Description Toggle screen mode Displays the remote screen either [Alt] + [F] as a full-screen or as a window on the local computer. Adjust video [Alt] + [V] Displays the Video Settings screen. Toggle OSD [Alt] + [O] Toggles the remote control panel on and off. Toggle pointer display [Alt] + [P] Toggles the mouse pointer of the local computer on and off, so that only the mouse pointer of the remote computer is displayed. Adjust mouse [Alt] + [M] Aligns the local and remote mouse pointers. Substitute Alt key [F12] Although all other keyboard input is captured and sent to the remote computer, the [Alt] + [Tab] and [Ctrl] + [Alt] + [Del] commands are still sent to your local computer. In order to use these commands on the remote system, another key must be substituted for the [Alt] key. If you substitute the [F12] key, for example, you would use [F12] + [Tab] and [Ctrl] + [F12] + [Del]. Note: By default, the substitute [Alt] key is [F12]. Exit: remote view [Alt] + [E] Disconnects and exits the remote session. 22