Tripp Lite B0930042E4UV Owners Manual for B093- B097- and B098-Series Console - Page 231
Date and Time Settings
View all Tripp Lite B0930042E4UV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 231 highlights
14. Configuration from the Command Line To configure the management LAN interface, use the same commands as above but replace: config.interfaces.wan, with config.interfaces.lan To enable the management LAN interface, run the following command: config -d config.interfaces.lan.disabled config -r ipconfig Note: Not all devices have a management LAN interface. To configure a failover device in case of an outage: # config -s config.interfaces.wan.failover.address1='ip address' # config -s config.interfaces.wan.failover.address2='ip address' # config -s config.interfaces.wan.failover.interface=[ eth1 | console | modem ] The network interfaces can also be configured automatically: # config -s config.interfaces.wan.mode=dhcp # config -s config.interfaces.lan.mode=dhcp The following command will synchronize the live system with the new configuration: # /bin/config --run=ipconfig The following command will synchronize the live system with the new configuration: # config -r ipconfig 14.1.18 Date and Time Settings To enable NTP using a server at pool.ntp.org, issue the following commands: # config -s config.ntp.enabled=on # config -s config.ntp.server=pool.ntp.org Alternately, you can manually change the clock settings: To change running system time: # date 092216452005.05 Format is MMDDhhmm[[CC]YY][.ss] The following command will save this new system time to the hardware clock: # /bin/hwclock --systohc Alternately, to change the hardware clock: # /bin/hwclock --set --date=092216452005.05 Format is MMDDhhmm[[CC]YY][.ss] The following command will save this new hardware clock time as the system time: # /bin/hwclock --hctosys To change the timezone: # config -s config.system.timezone=US/Eastern The following command will synchronize the live system with the new configuration: # config -r time 231