Tripp Lite B097016 Owners Manual for B093- B097- and B098-Series Console Serve - Page 226
Environmental, 1.11 Managed Devices
View all Tripp Lite B097016 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 226 highlights
14. Configuration from the Command Line 14.1.10 Environmental To configure an environmental monitor with the following details: Monitor name Envi4 Monitor Description Monitor in room 5 Temperature offset 2 Humidity offset 5 Enable alarm 1 ? yes Alarm 1 label door alarm Enable alarm 2 ? yes Alarm 2 label window alarm Logging enabled ? yes Log interval 120 seconds # config -s config.ports.port3.enviro.name=Envi4 # config -s "config.ports.port3.enviro.description=Monitor in room 5" # config -s config.ports.port3.enviro.offsets.temp=2 # config -s config.ports.port3.enviro.offsets.humid=5 # config -s config.ports.port3.enviro.alarms.alarm1.alarmstate=on # config -s config.ports.port3.enviro.alarms.alarm1.label=door alarm # config -s config.ports.port3.enviro.alarms.alarm2.alarmstate=on # config -s config.ports.port3.enviro.alarms.alarm2.label=window alarm # config -s config.ports.port3.enviro.alarms.total=2 # config -s config.ports.port3.enviro.log.enabled=on # config -s config.ports.port3.enviro.log.interval=120 It is important to assign alarms.total=2, even if they are off. The following five commands will add the environmental monitor to 'Managed devices': To get the total number of managed devices: # config -g config.devices.total Make sure to use the total + 1 for the new device below: # config -s config. devices.device5.connections.connection1.name=Envi4 # config -s "config. devices.device5.connections.connection1.type=EMD Unit" # config -s config. devices.device5.name=Envi4 # config -s "config. devices.device5.description=Monitor in room 5" # config -s config.devices.total=5 The following command will synchronize the live system with the new configuration: # config -a 14.1.11 Managed Devices To add a managed device: (also see UPS, RPC connections and Environmental) # config -s "config.devices.device8.name=my device" # config -s "config.devices.device8.description=The eighth device" # config -s "config.devices.device8.connections.connection1.name=my device" # config -s config.devices.device8.connections.connection1.type=[serial | Host | UPS | RPC] # config -s config.devices.total=8 (decrement this value when deleting a managed device) To delete the above managed device: # config -d config.devices.device8 The following command will synchronize the live system with the new configuration: # config -a 226