Tripp Lite PDUMV30NET Owner's Manual for Monitored/Switched Rack PDUs 933151 - Page 6

10 Installation continued 11 4-2 Configure Terminal Emulation Program: Open a VT100-compatible terminal emulation program (such as the HyperTerminal program bundled with Microsoft® Windows®) on a computer with an available DB9 serial port. (A notebook computer may be the most convenient choice.) Set the terminal emulation program to use the COM port that corresponds to the computer's DB9 serial port. Specify the parameters required to communicate with the PDU terminal interface: 12 Bits per second: Data bits: Parity: 9600 8 None Stop bits: Flow control: 1 None If the terminal emulation program supports multiple emulation modes, you may also need to specify VT100 emulation. 4-3 Connect PDU to Computer: Use the RJ-45 to DB9 serial cable (part number B 73-1243) included with the PDU to connect the PDU to the computer. The RJ-45 connector A at one end of the cable attaches to the CONFIG port B D on the PDU. The DB9 connector C at A the other end of the cable connects to the computer's serial port D . 4-3 C 4-4 Connect PDU to Network: While the PDU is powered, connect a standard Ethernet patch cable to the RJ-45 A STATUS LINK Ethernet port A on the PDU. Note: This port is not compatible with PoE (Power over Ethernet) applications. ACCY CONFIG RESET ENVIROSENSE 13 4-4 4-5 Configure PDU in Terminal Mode: After a brief pause, an initialization page should appear in the terminal emulation program. Press any key on the keyboard within 10 seconds to change the PDU settings. (If the 10-second period has elapsed, you can reboot the PDU by pressing the SNMP reset switch.) Follow the sequence of responses below in order to assign an IP address to the 4-5 PDU. The default terminal mode root password is TrippLite. Sample IP settings are shown - supply your own IP information when you configure your PDU. 14 15 6 201112142 933151.indb 6 16 1/24/2012 2:09:55 PM