Tripp Lite PDUMV30NET Owner's Manual for Monitored/Switched Rack PDUs 933151 - Page 9
Circuit Breakers Select Models
View all Tripp Lite PDUMV30NET manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
3 4 5 6 Features continued Circuit Breakers (Select Models): If the connected equipment load on a load bank exceeds the Maximum Load Rating of the load bank, the circuit breaker will trip. Disconnect excess equipment and switch breaker to the on position to reset the breaker. Models with multiple outlet banks have a circuit breaker for each bank. Circuit breakers are only used to protect output load banks. Cord Retention Bracket: Provides secure attachment points for connected equipment cords. 7 8 9 10 11 12 A 201112142 933151.indb 9 14 13 ENVIROSENSE RESET LINK 20 19 18 17 16 15 ACCY CONFIG STATUS Mounting Brackets: Use these brackets to mount the PDU. PDUMVROTATEBRKT Mounting Accessory: Use these V-shaped brackets to mount the PDU with its outlets facing the rear of the rack. SNMP Reset Button: Press the reset button A for 3 seconds to reboot the PDU's network card. Rebooting the network card will not erase network settings or interrupt AC power. The reset button is recessed; use a suitable tool to press it. ACCY Port: The port is reserved for future expansion. PS/2 Port: Use this port to connect a Tripp Lite ENVIROSENSE environmental sensor to provide remote temperature/humidity monitoring and a dry contact interface to control and monitor alarm, security and telecom devices. Visit www.tripplite.com for ordering information. Note: Do not connect a keyboard or mouse to this port. RJ-45 Configuration Port: Use this port to provide a direct terminal connection to a computer with a terminal emulation program. An RJ-45 cable is included with the PDU. If you need a replacement cable, visit www.tripplite.com for ordering information. 9 1/24/2012 2:09:59 PM 1