Tripp Lite SUINT3000LCD2U Owner s Manual for Single-Phase Rackmount On-line UP - Page 14

Operations Front Panel LCD Selection and Configuration Options MAIN MENU / SUBMENU STATUS Load Status In/Out Status Energy Status Int. Batt. Status Ext. BP. Status Power Flow Chart CONTROL Start Batt. Test Reset Batt. Age Reset Fault State Auto Batt. Testing EVENT LOG On Batt. Events All Events Reset Batt. Events Reset All Events SETTINGS Basic setup DISPLAY / SETTING OPTIONS DISPLAY / SETTING DESCRIPTION • Load level (%, kW, kVA, A, PF) • Available capacity (%, kW, kVA) • Input voltage & frequency (Vac, Hz) • Output voltage & frequency (Vac, Hz) • Load Group1 (On, Off) • Load Group2 (On, Off) • Efficiency (%) • Avg. Power (kw/hr.) • Configured power strategy • Installed (mm/dd/yyyy) • Expires (mm/dd/yyyy) • Battery pack model & serial number • Installed (mm/dd/yyyy) • Expires (mm/dd/yyyy) • View UPS operational flow chart UPS load percent (%), kilowatt (kW), kilovoltamp (kVA), amp (A) & power factor (PF). UPS capacity available in percent (%), kilowatts (kW) & kilovoltamps (kVA). Displays UPS input and output status information for input / output voltage (Vac), frequency (Hz) and outlet group power status (On/Off) information. Displays UPS efficiency percentage (%), connected equipment kilowatt hour consumption (kw/hr.) and configured power strategy. Displays internal Replacement Battery Cartridge install date and user configured expiration date. Displays external Battery Pack model number & serial number (Tripp Lite SMART BATTERY PACKS) only, installation date and user configured expiration date. Displays UPS operating mode in a graphical flow chart. • Initiates a manual battery test • Resets the battery age • Resets any fault state messages • Set regular battery self-test interval o Disable o 4 weeks (factory setting) o 13 weeks o 26 weeks Initiates a momentary UPS battery self-test with immediate Pass/Fail results. Resets battery age to today's date. Use this option after NONSMART battery replacement. Use this option to clear UPS fault messages. Use this option to initiate automatic UPS battery testing at regular intervals. • Event counter (UPS On-battery events only) • Total minutes (total minutes of on-battery mode operation) • Most recent power failure (date) • Days until battery replacement alert (days) • Event details (date, time & description for the last 20 logged events) • Event counter (all events) • Most recent event (date) • Date time log • Event details (date, time and description of each logged event) • Resets battery events only • Resets all events Displays a summary of all ON-BATTERY events where the UPS switched to battery mode in response to a protected condition. Event details lists the last 20 battery events. As additional alerts occur, the oldest records will be automatically removed. Displays a summary of all Recorded events. Event details lists the last 20 events. As additional alerts occur, the oldest records will be automatically removed. Resets all data in the on-battery events screen set. Resets all data in the all-events screen set. System • Current date (display, set date) • Current time (display, set time) • Audible alarm (enable, disable) • Language (select) Output voltage • 200 • 208 • 220 • 230 • 240 Displays, sets and resets date, time, audible alarm status and language settings. Note: Audible Alarm DISABLE setting prevents power fail and operating fault alarms only, the UPS will always "beep" to confirm the UPS is accepting user input from the front-panel LCD navigation buttons. Use the SETTINGS / BASIC / OUTPUT VOLTAGE option to display or set the nominal UPS output voltage (changes take effect on next restart). 14