Troy-Bilt Mustang 50 Operation Manual - Page 11
Lower Deck Discharge Chute Deflector, Adjusting the Seat - 50
View all Troy-Bilt Mustang 50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Lower Deck Discharge Chute Deflector WARNING! Never operate the mower deck without the chute deflector installed and in the down position. The discharge chute deflector must be installed before operating the mower. 1. Remove the keys that are attached with a zip tie to the chute bracket. 2. Remove the flange lock nuts from the deck. Do not remove the push nuts or carriage bolts, leaving them in place will aid in installing the chute. See Figure 3-5. Adjusting the Seat To adjust the position of the seat, rotate the seat forward and locate the clamp knob on the front left of the seat pan. Refer to Figure 3-2. Rotate the clamp knob to the left and remove it, slide the seat forward or backward and re-insert the clamp knob into one of the four available positions on the seat pan and into the seat, then tighten securely. Make sure the seat is locked into position before operating the tractor. See Figure 3-7. 50" Deck Shown Flange Lock Nuts Clamp Knob Push Nuts Carriage Bolts Seat Adjustment Positions Figure 3-5 3. Install the discharge chute deflector using the carriage bolts, push nuts and flange lock nuts as shown in Figure 3-6 and securely tighten the hardware. 50" Deck Shown Flange Lock Nuts Figure 3-7 Discharge Chute Deflector Push Nuts Carriage Bolts Figure 3-6 Section 2 - Assembly & Set-Up 11