Troy-Bilt Mustang 50 Operation Manual - Page 9
Assembly & Set-Up - deck
View all Troy-Bilt Mustang 50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Assembly & Set-Up 3 Contents of Crate • One RZT L Tractor • One Tractor Operator's Manual • One Oil Drain Tube • One Engine Operator's Manual • One Deck Wash Hose Coupler NOTE: This Operator's Manual covers several models. Tractor features may vary by model. Not all features in this manual are applicable to all tractor models and the tractor depicted may differ from yours. 2. Remove the two shoulder screws and flange lock nuts in the seat pan as shown in Figure 3-2. Tractor Preparation Manually Moving the Tractor Seat 1. Engage the transmission bypass rods, one on each side of Shoulder Screws Pan the tractor, to move the tractor manually without starting it. Clamp Knob The transmission bypass rods are located on the rear of the tractor, just inside each rear wheel. Engage the bypass rods by pulling each one out (a) and to the right (b) to lock it into place. See Figure 3-1. Wire Harness Flange Lock Nuts a b Figure 3-2 3. Rotate the seat into position and secure the seat into place with the previously removed shoulder screws and flange lock nuts. Be careful not to crimp or damage the wire harness while installing the seat. See Figure 3-2. NOTE: Be sure to push the excess wire from the wire harness into the seat box hole before continuing. Figure 3-1 2. Disengage the bypass rods by reversing steps a & b after moving the tractor. See Figure 3-1. 3. Remove the deck wash system nozzle adapter from the manual bag and store for future use. Install Operator's Seat To install the seat proceed as follows: NOTE: The seat is shipped with the seat switch and seat pan attached. 1. Cut any straps securing the seat assembly and the drive control levers to the tractor. Remove any packing material. NOTE: Be careful not to cut the wiring harness connecting the seat and the seat switch. 9