Troy-Bilt TB R18 Operation Manual - Page 6

Adjusting the Cutting Height The cutting height can be adjusted to between approximately 3/4-inch and 21/2-inches. 1. Move the right-hand height adjustment lever outward and then position it forward (to lower the cutting height) or rearward (to raise the cutting height) before releasing it into the notch for your desired height. See Fig. 3-4. Attaching the Grass Catcher (Model TBR18) 1. Expand the grass catcher from its collapsed position by opening up the hinges found on the inside of its frame. 2. Position the grass catcher hooks over the rod on the rear of the mower. See Fig. 3-5. Figure 3-5 Figure 3-4 3. Position the strap through the grass catcher's handle and over the mower's lower handle crossbar to support the rear 2. Repeat Step 1 on the left-hand side making sure to release the of the grass catcher. See Fig. 3-6. Adjust the length of the height adjustment lever into the corresponding notch. strap so that the bag is low to the ground but not dragging on the ground. 6 Section 3 - Assembly & Set-Up Figure 3-6