Troy-Bilt TB4HB Operation Manual - Page 1

ENGLISH - PAGE 1 TB4HB EC 4-Cycle Electric Start Capable Handheld Blower Operator's Manual Removing Unit From Carton Assemble The Unit Tools Required: • Flathead Screwdriver On/Off Switch Blower Outlet Throttle Control Primer Bulb Starter Rope 1 Remove all contents from the carton. 2 Insert the upper blower tube into the blower outlet and turn it clockwise until it locks into place. 3 Install the lower blower tube onto the upper blower tube and turn it clockwise until it locks into place. 4 Place the unit on a level surface, remove the oil plug from the crankcase, and pour the entire bottle of oil into the fill hole. Upper Blower Tube Lower Blower Tube Oil Plug Assemble The Unit Starting The Unit Primer Bulb 5 Place unit on a level surface. Fill fuel tank. 10 X 6 Press primer bulb 10 times, or until fuel is visible 7 Move choke lever to Position 1. 8 Crouch in starting position. Starting The Unit DIDN'T START? Repeat the starting instructions. IF engine fails to start after 2 attempts, move choke lever to position 3 and pull the starter rope until engine starts IF unit still fails to start, refer to operator's manual for additional starting and troubleshooting information 19 DO NOT squeeze throttle control. 5 X 10 Pull rope 5 times. 11 Move choke lever to Position 2 . 3-5 X 12 Pull rope 3-5 times to start engine. Squeeze throttle control and allow unit to warm up for 30-60 seconds. 13 Continue to squeeze throttle. Move choke lever to Position 3. 14 Continue to squeeze throttle. Warm unit for an additional 60 seconds to complete warm-up. Unit may be used during this time. FRANÇAIS - PAGE 6 ESPAÑOL - PAGE 11 IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT. NEED HELP? Call 1-800-828-5500 in U.S. or 1-800-668-1238 in Canada 769-06521 P00 03/11