Troy-Bilt TB516 Operation Manual - Page 1
Troy-Bilt TB516 Manual
View all Troy-Bilt TB516 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
TB516 EC Electric Start Capable 4-Cycle Lawn Edger Operator's Manual English - Page 1 Remove Unit From Carton Assemble The Unit NO TOOLS REQUIRED! 1 Remove all contents from the carton. Assemble The Unit 2 Slide the ends of the middle shaft over the ends of both lower shafts and align the holes. Insert bolts into the two holes. Install a washer and knob onto each bolt. Tighten the knobs securely. Keep the cables to the front of the unit. 3 Align the holes on the upper shaft with the holes on the middle shaft. Insert bolts into the two holes. Install a washer and knob onto each bolt. Tighten the knobs securely. Make sure the "V" bend in the handle is pointing up. Start The Unit Red Cold Weather Start Lever 4 Pull the starter rope through the eye hook. Insert the cables into the cable restraints on the lower and upper shafts. 5 Remove the oil plug from the crankcase, and pour the entire bottle of oil into the fill hole. Start The Unit Primer Bulb 6 Place unit on a level surface and fill fuel tank. DO NOT overfill. 7 For cold weather conditions (below 40°F), push the red cold weather start lever down to the closed position. DO NOT push this lever down if the temperature is above 40°F. 8 DO NOT squeeze the throttle. Red Cold Weather Start Lever Handle Throttle Control On/Off Control Starter Rope Grip Air Filter Cover Fuel Cap Oil Fill Plug Red Cold Weather Start Lever Spark Plug Primer Bulb DIDN'T START? IF the engine does not start, go back to step 9. IF the engine stops while squeezing the throttle, go back to step 10. IF the engine is hot, go back to step 9. Edger Blade Depth Adjustment Lever Blade Shield 10 X 19 Press primer bulb 10 times, or until fuel is visible 10 Stand in the starting position. 11 Pull the starter rope in a controlled motion until the unit starts. Wait 60 seconds. 12 For cold weather conditions (below 40°F), pull the red cold weather start lever back up to the open position after the unit starts. 13 Tip the unit back so the blade does not touch the ground. Squeeze the throttle control and allow the engine to warm up for 30 to 60 seconds. The unit may be used during this time. Español - Page 5 IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES WHILE OPERATING THE UNIT. NEED HELP? CALL 1-800-828-5500 IN U.S. OR 1-800-668-1238 IN CANADA 769-07491 P00 10/11