Troy-Bilt TB625 Operation Manual - Page 11
Using The Electric Start Accessory
View all Troy-Bilt TB625 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
USING THE ELECTRIC START ACCESSORY This unit can be started with an optional electric start accessory (items sold separately). Refer to the electric start accessory operator's manual for the proper use of this feature. Please contact your local retailer, call the Customer Support Department or visit our website for more information. Item No. Description 49M2027P966 Electric Starter 49MESCBP966 Engine Starter Bit 49MRBESP966 or 49MRBESY966 Cordless Electric Starter STARTING INSTRUCTIONS 1. Check the oil level. Refer to Checking the Oil Level. 2. Fill the fuel tank. Refer to Fueling the Unit. NOTE: There is no need to turn the unit on. The On/Off switch is in the ON ( I ) position at all times (Fig. 9). 3. Slowly press and release the primer bulb 10 times (Fig. 10). 4. Move the choke lever to Position 1 (Fig. 11). 5. Crouch in the starting position (Fig. 12). 6. Insert the electric start accessory into the electric start port (Fig. 13). Refer to the Operation section of the electric start accessory operator's manual. NOTE: SQUEEZE and HOLD the throttle control for ALL further steps. 7. Squeeze and hold the throttle control (Fig. 9). Run the electric start accessory for 2 seconds. 8. Continue to squeeze the throttle control. Move the choke lever to Position 2 (Fig. 11). 9. Continue to squeeze the throttle control. Run the electric start accessory in intervals no longer than 2 seconds each until the unit starts. 10. Remove the electric start accessory from the unit. 11. Continue to squeeze the throttle control. Allow the engine to warm up for 30 to 60 seconds. 12. Continue to squeeze the throttle control. Move the choke lever to Position 3 (Fig. 11) and continue warming the engine for an additional 60 seconds. The unit may be used during this time. IF... the engine does not start, begin the starting procedure with step 3. IF... the engine fails to start after a few attempts, move the choke lever to Position 3 and squeeze the throttle control. Run the electric start accessory in intervals no longer than 2 seconds each until the unit starts. The engine should start. If it does not, repeat this instruction. IF THE UNIT WAS RUN FOR 10-15 MINUTES AND THE ENGINE IS HOT... perform steps 3 - 10 to restart the engine. Continue to squeeze the throttle control. Run the unit for 2-5 minutes, or as needed. The unit may be used during this time. Then move the choke lever to Position 3. If the engine speed fluctuates in Position 3, squeeze and hold the throttle control, move the choke lever to Position 2, and run the unit for 2-5 minutes, or as needed. The unit may be used during this time. Then move the choke lever to Position 3. Fig. 13 Electric Start Port STOPPING INSTRUCTIONS 1. Release the throttle control and allow the engine to idle. 2. Press and hold the On/Off switch in the OFF (O) position until the engine comes to a complete stop (Fig. 9). 11