Uniden D3097 English Owner's Manual - Page 23
Resetting a Handset, Registering a Handset
View all Uniden D3097 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Answering system problems Possible solutions My outgoing message is gone. xxIf there was a power failure, re-record your personal outgoing message. I can't hear the base speaker. xxMake sure call screening is turned on. xxChange the base speaker volume. Messages are incomplete. xxIncrease the Record Time. xxDelete messages (memory may be full). The system keeps recording when I answer on an extension. xxYou may have to change the line mode. Contact Customer Service for instructions. Installing a Line Filter or DSL Filter A telephone line filter or DSL filter prevents services that use the phone line from causing interference on your phone. To get a line filter, contact your service provider or look in an electronics store. Plug the filter into the telephone wall jack and plug the base into the filter. Make a test call to make sure the noise is gone. Liquid Damage CAUTION: If the base is covered in liquid, disconnect the adapter and phone cord from the wall before touching it. If the liquid is only on the exterior housing of the base or handset, wipe it off and use as normal. If you can hear liquid inside the housing: 1. Disconnect all cables and cords and remove all compartment covers. 2. If liquid is leaking from any vent or hole, turn the phone so that vent faces down. If not, place the largest vent face down. 3. Let dry for at least 3 days. Check for liquid inside the phone before replacing compartment covers and reconnecting cords. Resetting a Handset If you have trouble with a handset or if you want to replace one, reset it: 1. Press and hold END/CLEAR and Pound (#) at the same time until System Reset displays (about 5 seconds). 2. If you still have the base the handset is registered to, select Deregister HS, then select the handset you want to reset. If you don't have that base anymore, select Base Unavailable. 3. To confirm, select Yes. The handset displays Handset not registered. Registering a Handset If you see a "not registered" message on a handset, you must register it to a base before using it. English - 23