Uniden DECT2180-2 English Owners Manual - Page 28

Registering a handset Does the handset fit in the base cradle? Yes No Place the handset 1. Disconnect the base AC adapter. in the base. The 2. Press and hold Find handset/Intercom while you display should reconnect the adapter. say Handset 3. On the handset, press and hold # until the display says Registering. Handset Registering (about 2 seconds). In about 30 seconds, the display should say Registration Complete. Pick up the handset & press Talk/flash: you should hear a dial tone. If... Try... - you don't hear a dial tone Making sure the handset is fully - the display says Registration Failed charged, then trying again. To register a handset to a different base, see the section "Expanding Your Phone" in the user's guide for the other base. Handling Liquid Damage Moisture and liquid can damage your cordless phone.  If the handset or base is exposed to moisture or liquid, but only the exterior housing is affected, wipe off the liquid, and use as normal.  If moisture or liquid has entered the plastic housing (i.e. liquid can be heard in the phone or liquid has entered the handset battery compartment or vent openings on the base), follow these steps: Handset Base 1. Remove the battery cover & disconnect the 1. Disconnect the AC battery. adapter to cut off the 2. Let dry for at least 3 days with the battery power. disconnected and the cover off for ventilation. 2. Disconnect the 3. After the handset dries, reconnect the battery telephone cord. pack and replace the cover. Recharge the 3. Let dry for at least 3 days battery fully (15-20 hours) before using. before reconnecting. IMPORTANT: You must unplug the telephone line while recharging the battery pack to avoid charge interruption. CAUTION! DO NOT use a microwave oven to speed up the drying process. This will cause permanent damage to the handset, base and the microwave oven. 26