Uniden DECT2188-3 English Owners Manual - Page 6

Connect the charger 1. Connect a charger AC adapter to each charger's AC IN 8V jack and set the plug into the notch as shown. (These adapters might already be connected.) 2. Plug the other end of the adapter into a standard 120V AC power outlet. AC IN 8V 3. Place each handset in a charger with the display facing forward. The charge light should turn on. If... Try... the charge - reseating the handset. light doesn't - checking the AC adapter connection. turn on - seeing if the outlet is controlled by a wall switch. Charge all handsets completely (about 15 hours) before using them. Test the connection Pick up each handset and press Talk. You should hear a dial tone, and the display should say Talk. (Press End to hang up.) If you can't get a dial tone or the handset display says Unavailable, try moving the handset closer to the base or resetting it (see page 28). Changing from Tone to Pulse Dialing Phones can communicate with the telephone network in two different ways: tone (DTMF) or pulse dialing. If you know your phone company uses pulse dialing or you can't make your test call, follow these steps: 1. With the phone in standby, press Menu/select on a cordless handset. (You must use a cordless handset for this procedure.) 2. Use Up or Down to highlight Global Setup, then press Menu/select. 3. Use Up or Down to highlight Dial mode, then press Menu/select. 4. Highlight Pulse, then press Menu/select. The phone sounds a confirmation tone. Try making another test call. If you use pulse dialing and you need to send DTMF tones during a call (if you're using an automated response system, for example), press to temporarily switch to tone dialing. When the call ends, the phone automatically returns to pulse dialing mode.